Several agro-waste materials have been utilized for sustainable engineering and environmental application over the past decades, showing different degrees of effectiveness. However, information concerning the wider use of palm oil clinker (POC) and its performance is still lacking. Therefore, as a solid waste byproduct produced in one of the oil palm processing stages, generating a huge quantity of waste mostly dumped into the landfill, the waste-to-resource potential of POC should be thoroughly discussed in a review. Thus, this paper provides a systematic review of the current research articles on the several advances made from 2005 to 2021 regarding palm oil clinker physical properties and performances, with a particular emphasis on their commitments to cost savings during environmental and engineering applications. The review begins by identifying the potential of POC application in conventional and geopolymer structural elements such as beams, slabs, and columns made of concrete, mortar, or paste for coarse aggregates, sand, and cement replacement. Aspects such as performance of POC in wastewater treatment processes, fine aggregate and cement replacement in asphaltic and bituminous mixtures during highway construction, a bio-filler in coatings for steel manufacturing processes, and a catalyst during energy generation are also discussed. This review further describes the effectiveness of POC in soil stabilization and the effect of POC pretreatment for performance enhancement. The present review can inspire researchers to find research gaps that will aid the sustainable use of agroindustry wastes. The fundamental knowledge contained in this review can also serve as a wake-up call for researchers that will motivate them to explore the high potential of utilizing POC for greater environmental benefits associated with less cost when compared with conventional materials.
One of the most challenging aspects of environmental conservation is the treatment of dye wastewater. Thus, this mini-review discussed the issues and major advances in the application and performance assessment of the aerobic, anaerobic, anaerobic-aerobic, aerobic-anaerobic, and anoxic–aerobic REACT-operated SBR systems with regards to bio-decolorization and COD removal rates. In SBRs run in aerobic modes, it is possible to cultivate aerobic granular sludge for color removal. To be precise, SBR has a higher COD removal efficiency with a lower color removal efficiency. Under anaerobic conditions, lesser COD removal was observed for several dyes studied in this chapter. In an alternating anaerobic-aerobic SBR system, color removal tends to occur during the anaerobic phase, while the aerobic phase is required to further reduce the effluent COD concentration. However, molecular oxygen drastically reduced color removal in SBR during dye wastewater treatment. This chapter discusses the aerobic-SBR treatment process for dye removal. The discussion focused on dye wastewater treatment using aerobic granules, granular activated carbon, adsorbents, biocarrier white rot fungi, varying dye mixtures, dye concentrations and SBR operational parameters. Adsorbents, membranes, biocarriers, exported microbial cultures, and various operational conditions have also been used in sequential anaerobic/aerobic batch reactors to enhance system performance. This chapter assessed the different treatment mechanisms and dynamics and concluded that combining two treatment methods significantly yields better color, DOC, and BOD5 removal than a single biological or chemical treatment.