Field effect-based biosensors (BioFETs) stand out among other biosensing technologies due to their unique features such as real time screening, ultrasensitive detection, low cost, and amenability to extreme device miniaturization due to the convenient utilization of nanoscale materials. Nanodevices pave the way for the detection of tiny biomolecules and minute concentrations of analytes as they are ultrasensitive to surface charge modulation, allowing for better point-of-care screening of various life-threatening infectious diseases. Semiconducting carbon nanotubes (sc-CNTs) are exceptionally promising for FET-channel integration to replace bulky silicon technology beyond the dimensions of the short channel effects for their 1D ultrathin structure, superior electronic features, and biocompatibility. However, performance of CNTFET biosensors is influenced by the inhomogeneous interface between sc-CNTs and metallic source and drain electrodes. This article reviews recent studies on CNTFET biosensors, morphology of these devices and the cause-and-effect of the interface issues between sc-CNTs and metallic electrodes. Finally, future outlook on suggested technology to improve the performance of such CNTFET devices is presented.
This work describes the fabrication and characterization of a Micro-Electro-Mechanical System (MEMS) sensor for gas sensing applications. The sensor is based on standard PolyMUMPs (Polysilicon Multi-Users MEMS Process) technology to control the temperature over the sensing layer. Due to its compact size and low power consumption, micro-structures enable a well-designed gas-sensing-layer interaction, resulting in higher sensitivity compared to the ordinary materials. The aim of conducting the characterization is to compare the measured and calculated resistance values of the micro-heater and the temperature sensor. The temperature coefficient of resistance (TCR) of the temperature sensor has been estimated by raising and dropping the temperature throughout a 25–110 °C range. The sensitivity of these sensors is dependent on the TCR value. The temperature sensor resistance was observed to rise alongside the rising environmental temperatures or increasing voltages given to the micro-heater, with a correlation value of 0.99. When compared to the TCR reported in the literature for the gold material 0.0034 °C, the average TCR was determined to be 0.00325 °C and 0.0035 °C, respectively, indicating inaccuracies of 4.6% and 2.9%, respectively. The variation between observed and reported values is assumed to be caused by the fabrication tolerances of the design dimensions or material characteristics.
16 January 2023 in International Journal of Technology
Carbon nanotubes (CNTs) are very promising nanodevices due to their extraordinary electrical, thermal, and optical properties. However, as-grown single-walled CNTs (SWCNTs) contain a mixture of semiconducting and metallic species with great features versatility and variation. Solution-based processing of this nanomaterial is vital for further implementation in applicable platforms. In this paper, important optoelectronic intrinsic properties of SWCNTs in dispersions are studied applying a semi-empirical approach of optical characterization and Tauc/Davis-Mott relation and Max-Planck equations. SWCNTs are found to have a direct bandgap of 2.20 eV, an indirect bandgap of 0.27 eV, an optical conductivity of about 107 S cm-1, and exhibited a metamaterial behavior ascribed to the high negative permittivity. In addition, the optimum parameters for the dispersion of SWCNTs, and the separation of the semiconducting species using simple mechanical methods of ultrasonication and density gradient ultracentrifugation, respectively, without using surfactants are also presented.