The article is devoted to the problem of proton-exchange membrane fuel cells (PEMFCs) integration into power supply systems. A hybrid energy complex (HEC) based on PEMFCs and lithium iron phosphate batteries can be used as a reliable energy source. It is necessary to properly determine the PEMFC characteristics in order to develop a PEMFC-based HEC prototype and its control algorithms. This paper presents a 1 kW PEMFC’s test results in steady and dynamic modes. The dependences of the average hydrogen consumption per 1 min, the volume of hydrogen for the generation of 1 kWh, the PEMFC efficiency on the load current were obtained and an analysis of these dependences for steady operation modes was performed. A range of load changes beyond which the efficiency of the PEMFC significantly decreased and it was recommended to switch to the joint operation of the PEMFCs and batteries (or only batteries) was established. Diagrams of the PEMFC output voltage during the dynamic changes in loads are presented and an analysis of transient response characteristics was carried out. The air supply fans were found to affect the performance of PEMFCs.
The article deals with the urgent task of creating a technological and production basis for the development and serial production of energy storage systems with flow batteries and uninterruptible power systems based on them. Flow batteries are a highly efficient solution for long-term energy storage in critical and alternative energy facilities. The main advantage of the flow batteries is the ability to create a system with the required power and capacity without redundant parameters due to the fact that the characteristics of the system are regulated by independent blocks, as in a fuel cell. Among flow batteries, vanadium redox flow batteries (VRFB) are of particular interest, as they have a long service life. The main elements of a flow battery are the stack, which determines the power of the battery and its efficiency, and the electrolyte, which determines the energy capacity of the battery and its service life. A stand for testing the operating modes of the flow battery stack has been developed. A 5 kW flow battery operating on an electrolyte with the addition of hydrochloric acid, which is a stabilizer in new generation electrolytes, has been tested.
At the present stage of electric power industry development, special attention is being paid to the development and research of new efficient energy sources. The use of hydrogen fuel cells is promising for remote autonomous power supply systems. The authors of the paper have developed the structure and determined the optimal composition of a hybrid generation system based on hydrogen fuel cells and battery storage and have conducted studies of its operating modes and for remote consumers’ power supply efficiency. A simulation of the electromagnetic processes was carried out to check the operability of the proposed hybrid generation system structure. The simulation results confirmed the operability of the structure under consideration, the calculation of its parameters reliability and the high quality of the output voltage. The electricity cost of a hybrid generation system was estimated according to the LCOE (levelized cost of energy) indicator, its value being 1.17 USD/kWh. The factors influencing the electricity cost of a hydrogen generation system have been determined and ways for reducing its cost identified.
Vanadium redox flow batteries are a highly efficient solution for long-term energy storage. They have a long service life, low self-discharge, are fire safe and can be used to create a large-scale storage system. The characteristics of the flow battery are determined by the parameters of its main components: a stack determines the battery power and its efficiency, and an electrolyte determines the battery’s capacity and service life. Several stacks must be combined into one system to create a powerful energy storage system; however, the discharge characteristics differ even for two identical stacks connected in parallel. This article proposes hydrodynamic and electrotechnical methods for ensuring the parallel operation of several flow stacks under the same conditions.
Vanadium redox flow batteries are promising energy storage devices and are already ahead of lead–acid batteries in terms of installed capacity in energy systems due to their long service life and possibility of recycling. One of the crucial tasks today is the development of models for assessing battery performance and its residual resource based on the battery’s present state. A promising method for estimating battery capacity is based on analyzing present voltage and current values under various load conditions. This paper analyzes the discharge characteristics of a 10 kW all-vanadium redox flow battery at fixed load powers from 6 to 12 kW. A linear dependence of operating voltage and initial discharge voltage on load power is established. It is also determined that the slope of the discharge curve linear section does not increase linearly in absolute value, and the Box–Lucas model can be used to describe it. Models for predicting current VRFB capacity based on different curve fitting functions are proposed. These models can be used to roughly estimate battery capacity at different load powers.
The paper is focused on the new approach to electric power distribution. Following the analogy of telecommunications network and power grids evolution a power packetizing technology is proposed. The new concept of the Packet Power Grid (PPG) is proposed as a set of different power sources and power consumers joined by power lines and electronic switches controlled by a supporting information computer network. Different electrical sensors form an important part of the PPG as well. The paper overviews the PPG as the next power grid evolution step after the Smart Grid. The PPG approach solves a number of problems of open concurrent power market development e.g. highly-efficient energy usage and numerous small sources adoption. The growing Packet Power Grid can play the role of the global power highway the same way as the Internet plays the role of the global information highway.