BiCuSeO oxyselenides are promising thermoelectric materials at intermediate temperatures, primarily due to their ultralow lattice thermal conductivity (κL) and high Seebeck coefficient. The intrinsically low carrier mobility in these materials, normally below ∼20 cm2 V−1 s−1 at 300 K, however, largely limits further improvements of their thermoelectric properties. In this study, by introducing less electronegative Te into the conductive Cu–Se layers, we demonstrate that the enhanced chemical bond covalency results in smaller effective mass and thus improved carrier mobility, through the weakening of carrier-phonon coupling. The improved carrier mobility by Te-doping largely retains the electrical conductivity values and thus high power factors even with decreased carrier concentrations. Meanwhile, the hierarchical structural features including dual point defects, nanoinclusions, grain boundaries, etc., originating from the nonequilibrium self-propagating high-temperature synthesis (SHS) processes, further reduce κL close to the amorphous limit. Ultimately, a maximum ZT value of ∼1.2 at 873 K is achieved in Bi0.96Pb0.04CuSe0.95Te0.05O, ∼35% improvement as compared with that of Te-free Bi0.96Pb0.04CuSeO and ∼2.4 times higher than that of the pristine sample. Furthermore, our study elucidates that weakening of carrier–phonon coupling through regulating chemical bonding within the conductive functionalities can be an effective avenue for further improving the thermoelectric performance of BiCuSeO.
BiCuSeO oxyselenides are promising thermoelectric materials, yet further thermoelectric figure of merit ZT improvement is largely limited by the inferior electrical transport properties. The established literature on these materials shows only one power factor maximum upon carrier concentration optimization, which is typical for most thermoelectric semiconductors. Surprisingly, we found three power factor maxima when doping Bi with Pb. Based on our first-principles calculations, numerical modeling, and experimental investigation, we attribute the three maxima to the Fermi energy optimization, band convergence, and compositing effect due to in situ formed PbSe precipitates. Consequently, three ZT peaks of 0.9, 1.1, and 1.3 at 873 K are achieved for 4, 10, and 14 at.% Pb-doped samples, respectively, revealing the significance of complex electronic structure and multiple roles of Pb in BiCuSeO. The results establish an accurate band structure characterization for BiCuSeO and identify the role of band convergence and nanoprecipitation as the driving mechanism for high ZT.
SHS process reduces period from over 10 h to less than 1 min, and thermal analysis indicates the ignition temperature of BiCuSeO approaches the second lower melting point of the compound. ZT = 0.91 at 873 K for Bi 0.96 Pb 0.04 CuSeO was achieved.
13 January 2017 in Journal of the American Ceramic Society