This paper presents a virtual cogging torque (VCT) control method to reduce the speed ripple of direct-drive permanent magnet synchronous machine (DD-PMSM) servo system under low-speed conditions. Compared with other factors, at low speeds, the cogging torque is the main factor that deteriorates the drive performance, even induces speed oscillations. Especially in this paper, due to volume limitation, the cogging torque is designed larger than normal one in order to remove the need of brake. Based on the model of PMSM, the cause and effect of the cogging torque are analyzed. Inspired by the characteristic of cogging torque, the VCT control method is proposed and investigated to significantly reduce the speed ripple at low speeds. The main idea of this proposed control method is to produce a proper virtual cogging torque and continuously move the corresponding virtual stable equilibrium point to drive the rotor smoothly. In addition to the principle of this control method, its analysis and implementation are studied as well. Simulation and experimental results from the prototype demonstrate that the proposed control method is correct and valid, and it is simple and effective to smooth the speed at low-speed operations.
1 February 2015 in IEEE Transactions on Power Electronics
This paper presents a wide-speed-range-operation dual stator-winding induction generator (DWIG) dc generating system for wind power applications. In this system, the dc bus on the control-winding side and the dc bus on the power-winding side are connected in parallel to further widen the speed range of the constant dc voltage output, especially at low speeds. Based on the control mechanism of the DWIG and the instantaneous power theory, a control-winding-flux-orientation control strategy is employed. In order to improve the wind energy conversion efficiency at low wind speeds, the generator efficiency optimization method is investigated. The experimental results from a 20 kW/600 V prototype show that the proposed generating system can output the constant dc voltage in a speed range of 1:4, and the generator efficiency in the low speed range is improved, which both bring the advantages for wind power applications, such as expanding the scope of the wind energy utilization and capturing much more wind energy.
25 October 2018 in IEEE Transactions on Industry Applications
In this paper, a novel tubular transverse-flux flux-reversal linear motor (TTFFRLM) for long stroke applications is proposed. The proposed motor not only has the low cost advantage of the existing flux-reversal permanent magnet (PM) LM by combining both PMs and armature winding in short primary, but also address the problem of complicated structure in conventional tubular PMLM by using manufacturing process of the rotary motor. First, in order to reduce circumferential magnetic flux leakage and improve the utilization ratio of PM, the motor structure with the alternating distribution of double N-poles and double S-poles in the circumferential direction is designed, and the operating principle of the motor are presented. Then, the equivalent magnetic circuit model (EMCM) of the unit motor is established to derive the expressions of the back electromotive force (EMF) and the electromagnetic thrust. Third, the equivalent 2-D finite element method (FEM) is used to optimize the structural dimensions and analyze the static characteristics including the back-EMF, the detent force and the thrust. Meanwhile, the 3-D FEM verify the validity of the equivalent 2-D FEM. Finally, the experimental results verify the validity and the correctness of the topology structure and the design method of the motor.
27 September 2010 in IEEE Transactions on Energy Conversion
This paper presents an optimal scheme of excitation capacitor to decrease the capacity of static excitation controller (SEC) for dual stator-winding induction generator (DWIG) system applied in wind power generation. The investigations into reactive excitation power released by the excitation capacitor and SEC illustrate that the optimal excitation capacitor is not only related to generator parameters, speed range, and load, but also affected by wind turbine power curve. Based on the objective of minimizing the capacity of SEC, several methods are employed here to select an appropriate excitation capacitor. Through the analysis of DWIG control mechanism and model of SEC in the stator-voltage-orientation synchronous d-q frame, a decoupling control strategy using the space vector modulation is obtained. On the basis of this, the simulation and experimental works from the prototype of 18-kW six/three-phase DWIG wind power system are carried out to verify the optimal scheme. The results demonstrate the correctness and effectiveness of this optimization scheme.
16 July 2018 in IEEE Transactions on Industrial Electronics
This paper presents a five-phase dual random space vector pulse width modulation (FPDR-SVPWM) strategy with an optimized probability density function (PDF) for a five-phase voltage-source inverter, and its performance and evaluation are also analyzed. Based on the Nearest Four Vectors modulation method, the FPDR-SVPWM strategy, combined with random switching frequency and random zero vector, is investigated to significantly reduce the amplitude of high-order harmonics near the switching frequency and its integer multiples. For non-sinusoidal power supply, third harmonic injection is introduced in this modulation strategy as well. Considering the effect of random numbers on the performance, an optimized Beta distribution is studied in detail. In order to analyze harmonic dispersion degree qualitatively and quantitatively, the power spectral density and the harmonic spread factor are both employed to assess the performance of the FPDR-SVPWM strategy. A series of results of simulation in Matlab and experiments based on Field Programmable Gate Array (FPGA) demonstrate that the proposed modulation strategy is correct and valid, and it distributes high-order harmonics into a wide range without affecting the fundamental wave and third harmonic.
1 April 2014 in IEEE Transactions on Power Electronics
This paper presents the control strategy and dynamic performance of the dual stator-winding induction generator variable frequency ac (VFAC) generating system with inductive and capacitive loads. In this generating system, the power winding produces the VFAC electricity to feed loads, and the control winding is connected to a static excitation converter to keep the output voltage stable. Based on the change law of the reactive power provided by the control winding, an improved instantaneous slip frequency control (IISFC) strategy both with the load active and reactive power feedforward is proposed to improve the system dynamic performance. The information of the load active and reactive power is employed through two feedforward loops to rapidly change the reactive power provided by the control winding, so as to quicken the regulation of the slip frequency and excitation reactive power. The simulations and experimental results show that the system using the IISFC strategy has a good dynamic performance with inductive and capacitive loads, and demonstrate the correctness and validity of the proposed control strategy.