Wenxin Huang

Prof. Wenxin Huang


Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 July 2018 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
XLXiaogang Lin
Xiaogang Lin
WHWenxin Huang
Wenxin Huang
LWLe Wang
Le Wang
Owing to high driving power, good controllability and strong fault-tolerant ability, three-phase open-end winding permanent magnet synchronous motor(OEW-PMSM) driven by dual inverter with common dc bus is considered as a competitive solution. However, a path for zero-sequence current is provided in this drive topology. Thus, the system loss would be increased, and the maximum output power is limited. In order to suppress the zero-sequence current, a novel space vector pulse width modulation(SVPWM) strategy based on hysteresis controller of zero-sequence current is proposed in this paper. The voltage vectors, whose polarity of zero sequence voltages(ZSVs) are opposite with the polarity of zero-sequence current, are selected as the basic voltage vectors of SVPWM for fundamental plane. Meanwhile, the linear modulation range is analyzed. According to analysis results, the proposed strategy has advantage of wide linear modulation range of zero-sequence voltage under the condition of high fundamental modulation ratio. The experimental results show that the zero-sequence current is effectively suppressed by the proposed modulation strategy. Furthermore, comparative evaluation of the proposed modulation strategy, the conventional SVPWM, the SVPWM with zero ZSVs and the zero vector redistribution(ZVR) SVPWM with zero-sequence current PR controller is conducted to demonstrate the superiority of the proposed strategy.

18 August 2021 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
SZShanfeng Zhu
Shanfeng Zhu
WHWenxin Huang
Wenxin Huang
YZYajun Zhao
Yajun Zhao
XLXiaogang Lin
Xiaogang Lin
DDDingfeng Dong
Dingfeng Dong
XWXu Wu
Xu Wu
Active disturbance rejection control using extended state observer (ESO) is less dependent on the knowledge of the system. It has proved to be an excellent scheme for speed control of electrical drives. However, for time-varying disturbance, the observation precision of conventional ESO is undesired, which limits the speed tracking accuracy. Accordingly, this article proposes an enhanced speed controller for electrical drives based on adaptive switching high-order ESO (ASHESO). First, the critical parameters affecting the steady-state performance of ASHESO are determined according to frequency analytical results. Then, optimized observer gain is obtained by modifying a part of pole locations, which weakens the influence of noise on estimated state. Finally, an adaptive switching gain mechanism is proposed according to the closed-loop tracking error and the swiftness of dynamic response is maintained. The proposed speed controller has achieved high estimation accuracy for disturbance and strong immunity to measurement noise. The feasibility and effectiveness of the strategy is verified on a laboratory permanent magnet synchronous motor (PMSM) drive system.

16 April 2020 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
XWXu Wu
Xu Wu
WHWenxin Huang
Wenxin Huang
XLXiaogang Lin
Xiaogang Lin
WJWen Jiang
Wen Jiang
YZYong Zhao
Yong Zhao
SZShanfeng Zhu
Shanfeng Zhu
The traditional direct toque control (TDTC) for induction motors (IM) is afflicted by large torque ripple, high current total harmonic distortion (THD) and variable switching frequency. Recently, some improved DTC methods have been proposed to address the above problems, but they often suffer from the obscure concept, intensive computation and poor robustness. To further improve the performance, this paper proposes a DTC method based on minimum voltage vector (VV) error. The proposed strategy effectively optimizes the duty ratio of fundamental VV to minimize the error between reference VV and final VV imposed on motor terminals. The optimization algorithm dose not increase the system's complexity much and can be intuitively understood by a graphical interpretation. Experiment comparisons between the proposed strategy and some existing DTC methods are conducted on a 0.55-kW IM platform. The proposed DTC method is proved to achieve better steady-state performance, meanwhile retaining fast dynamic response of TDTC. Furthermore, the proposed method can obtain almost constant average switching frequency in the whole speed range especially with rated load, due to the utilization of proportional-integral type torque regulator.

14 August 2019 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
XLXiaogang Lin
Xiaogang Lin
WHWenxin Huang
Wenxin Huang
WJWen Jiang
Wen Jiang
YZYong Zhao
Yong Zhao
DDDingfeng Dong
Dingfeng Dong
XWXu Wu
Xu Wu
This paper introduces the classical direct torque control (DTC) to three-phase open-end winding permanent magnet synchronous motor (OEW-PMSM) with common dc bus for the first time. The electromagnetic torque and stator flux are controlled at the same time. However, the zero-sequence current is not suppressed, and the ripples of electromagnetic torque and stator flux are large. To improve the operation performance of this drive system, a DTC based on duty ratio modulation (DRM-DTC) is proposed. Firstly, a deadbeat zero-sequence current controller (DB-ZSCC) is proposed in the DRM-DTC to suppress the zero-sequence current. Secondly, another strategy, which is based on a graphical analysis method and a simple deadbeat direct torque and flux controller (DB-DTFC), is proposed to optimize the duty ratio of active voltage vector. Thus, the electromagnetic torque and stator flux ripples can be reduced. Finally, an optimized PWM implementation strategy is proposed in the DRM-DTC to further reduce the switching frequency of inverters. The classical DTC and the proposed DRM-DTC are compared through simulation and experiment, and the results verify the effectiveness of the proposed strategy.

25 October 2018 in IEEE Transactions on Industry Applications
Verified
Journal Article
Closed access
DDDingfeng Dong
Dingfeng Dong
WHWenxin Huang
Wenxin Huang
FBFeifei Bu
Feifei Bu
QWQi Wang
Qi Wang
In this paper, a novel tubular transverse-flux flux-reversal linear motor (TTFFRLM) for long stroke applications is proposed. The proposed motor not only has the low cost advantage of the existing flux-reversal permanent magnet (PM) LM by combining both PMs and armature winding in short primary, but also address the problem of complicated structure in conventional tubular PMLM by using manufacturing process of the rotary motor. First, in order to reduce circumferential magnetic flux leakage and improve the utilization ratio of PM, the motor structure with the alternating distribution of double N-poles and double S-poles in the circumferential direction is designed, and the operating principle of the motor are presented. Then, the equivalent magnetic circuit model (EMCM) of the unit motor is established to derive the expressions of the back electromotive force (EMF) and the electromagnetic thrust. Third, the equivalent 2-D finite element method (FEM) is used to optimize the structural dimensions and analyze the static characteristics including the back-EMF, the detent force and the thrust. Meanwhile, the 3-D FEM verify the validity of the equivalent 2-D FEM. Finally, the experimental results verify the validity and the correctness of the topology structure and the design method of the motor.

16 July 2018 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
FBFeifei Bu
Feifei Bu
TPTianyu Pu
Tianyu Pu
WHWenxin Huang
Wenxin Huang
LZLin Zhu
Lin Zhu
This paper presents a five-phase dual random space vector pulse width modulation (FPDR-SVPWM) strategy with an optimized probability density function (PDF) for a five-phase voltage-source inverter, and its performance and evaluation are also analyzed. Based on the Nearest Four Vectors modulation method, the FPDR-SVPWM strategy, combined with random switching frequency and random zero vector, is investigated to significantly reduce the amplitude of high-order harmonics near the switching frequency and its integer multiples. For non-sinusoidal power supply, third harmonic injection is introduced in this modulation strategy as well. Considering the effect of random numbers on the performance, an optimized Beta distribution is studied in detail. In order to analyze harmonic dispersion degree qualitatively and quantitatively, the power spectral density and the harmonic spread factor are both employed to assess the performance of the FPDR-SVPWM strategy. A series of results of simulation in Matlab and experiments based on Field Programmable Gate Array (FPGA) demonstrate that the proposed modulation strategy is correct and valid, and it distributes high-order harmonics into a wide range without affecting the fundamental wave and third harmonic.