The development of high thermally conductive polymer composites with low filler content remains challenging in the field of thermal interface materials (TIMs). Herein, we fabricated a series of flexible fiber membranes (TMMFM) with high thermally conductive based on thermoplastic polyurethane (TPU) and acidified multiwalled carbon nanotubes (a-MWCNTs) via electrospinning and ultrasonic anchoring method. The SEM and TEM results demonstrated that the a-MWCNTs aligned along the fiber orientation in the membrane and anchored on the membrane surface strongly, which can establish the heat conduction path both in the horizontal and vertical directions. With the incorporation of 10 wt% a-MWCNTs, the horizontal direction (λ∥) and vertical direction (λ⊥) thermal conductivity value of TMMFM-5 was 3.60 W/mK and 1.79 W/mK, respectively, being 18 times and 10 times higher compared to pure TPU fiber membranes. Furthermore, the TMMFM maintained favorable flexibility of the TPU matrix because the small amount of a-MWCNTs only slightly hinders the mobility of the TPU molecular chain. The performance of the obtained TMMFM unveils their potential as a promising choice of flexible TIMs.
The high thermal conductivity and good insulating properties of boron nitride (BN) make it a promising filler for high-performance polymer-based thermal management materials. An easy way to prepare BN-polymer composites is to directly mix BN particles with polymer matrix. However, a high concentration of fillers usually leads to a huge reduction of mechanical strength and optical transmission. Here, we propose a novel method to prepare polyethylene/boron nitride nanoplates (PE/BNNPs) composites through the combination of electrostatic self-assembly and hot pressing. Through this method, the thermal conductivity of the PE/BNNPs composites reach 0.47 W/mK, which gets a 14.6% improvement compared to pure polyethylene film. Thanks to the tight bonding of polyethylene with BNNPs, the tensile strength of the composite film reaches 1.82 MPa, an increase of 173.58% compared to that of pure polyethylene film (0.66 MPa). The fracture stress was also highly enhanced, with an increase of 148.44% compared to pure polyethylene film. Moreover, the addition of BNNPs in PE does not highly reduce its good transmittance, which is preferred for thermal management in devices like light-emitting diodes. This work gives an insight into the preparation strategy of transparent and flexible thermal management materials with high thermal conductivity.