This work provides the results of the complex relative dielectric permittivity ε = ε ′ − i ε ″ (CRP) measurement and nuclear magnetic resonance (NMR) response of the quartz powders and cores of different porosity at stepped moistening and drainage. It is shown that CRP and NMR responses are ambiguous functions on water. The character of the CRP hysteresis depends on the electromagnetic field frequency, on the particle size and water salinity. The analysis of the NMR data shows that firstly the larger pores are filled with water at moistening and they are also drained first. Thus at the same water content, which is obtained in both the processes of moistening and drainage, pores of different sizes are filled. Herewith the water droplets have different curvature radiuses and different wetting contact angles which is the main cause of the hysteresis in the CRP and NMR response.
Using an MST-05 NMR relaxometer, we determined the dependence of NMR parameters on the specific surface and resistivity of water-saturated shaly sandstone and siltstone core samples. The influence of the type and quantity of clay minerals was evaluated at residual water saturation, because the main contribution to the measured NMR signal in this case is made by clay content. Based on NMR relaxometry data, we obtained quantitative estimates of the specific surface with clay- and capillary-bound fluids. The surface relaxivity was estimated from thermal-desorption and NMR relaxometry data. The high degree of reliability of its values was confirmed by the agreement between the pore size distributions determined by NMR relaxometry and by capillarimetry and granulometry. We have established that the parameters of NMR spectra depend on the specific surface and resistivity, which are, in turn, a function of the surface properties of both clay and sandstone/siltstone particles.
This article deals with the topical problem of estimating water content in water–oil mixtures within porous media they saturate, according to low-field NMR relaxometry and dielectric spectroscopy. The aim of the research is experimental validation of the capability of complex data interpretation to acquire information on the filtration-volumetric properties of drill cuttings, relaxation characteristics of oil-containing fluids, the water/oil ratio in water–oil mixtures, and their saturation of drill cuttings to control the composition of liquids produced from boreholes. The studies are carried out on samples of cuttings and oils taken from fields in the Northern regions of the West Siberian oil-and-gas province, where NMR studies have not been performed before. Based on the experimental data obtained, the possibility of water content assessment in water-in-oil mixtures and porous media they saturate were proved through NMR relaxometry. With the use of the proposed methodology, the amount of water in oil–water mixtures was established, and their main NMR characteristics were determined. The relative error in evaluating the proportion of water in mixtures based on high-viscosity oils is less than 10%, and about 20% for those based on light oils. When determining the oil–water ratio in the pore space of the drill cuttings, the error is about 15%. It was proven that joint use of these two techniques makes it possible to increase the reliability of the oil–water ratio assessment of all the samples studied. Furthermore, it was revealed that the NMR spectrum shifts to the right, and the spectrum of the complex permittivity shifts downwards during the transition from high-viscosity oils to light ones.
The measurement of the frequency dependences of the complex relative permittivity (CRP) of fully or partially saturated with distilled water rocks with different petrophysical characteristics is carried out. NMR relaxometer is used to determine the rocks pore size and porosity. There are two relaxation areas on the frequency dependence of CRP at partial saturation. Simulation was carried out by the two relaxation model of the Cole-Cole. High-frequency relaxation is due to the polarization at the water-air interface. The low-frequency relaxation is due to the polarization at the water-mineral interface. The model parameters are related to the petrophysical characteristics of the rocks. Analysis of the NMR response showed that water redistribution between large and small pores occurs with a decrease of the water content. It also affects the dielectric spectra.