On 28 September 2018, an Mw 7.4 earthquake, followed by a tsunami, struck central Sulawesi, Indonesia. It resulted in serious damage to central Sulawesi, especially in the Palu area. Two descending paths of the Advanced Land Observation Satellite 2 (ALOS-2) synthetic aperture radar (SAR) data were processed with interferometric synthetic aperture radar (InSAR) and pixel tracking techniques to image the coseismic deformation produced by the earthquake. The deformation measurement was used to determine the fault geometry and the coseismic distributed slip model with a constrained least square algorithm based on the homogeneous elastic half-space model. We divided the fault into four segments (named AS, BS, CS and DS, from the north to the south) in the inversion. The BS segment was almost parallel to the DS segment, the CS segment linked the BS and DS segments, and these three fault segments formed a fault step-over system. The Coulomb failure stress (CFS) change on the causative fault was also calculated. Results show that the maximum SAR line-of-sight (LOS) and horizontal deformation were −1.8 m and 3.6 m, respectively. The earthquake ruptured a 210-km-long fault with variable strike angles. The ruptured pattern of the causative fault is mainly a sinistral slip. Almost-pure normal characteristics could be identified along the fault segment across the Palu bay, which could be one of the factors resulting in the tsunami. The main slip area was concentrated at the depths of 0–20 km, and the maximum slip was 3.9 m. The estimated geodetic moment of the earthquake was 1.4 × 10²⁰ Nm, equivalent to an earthquake of Mw 7.4. The CFS results demonstrate that the fault step-over of 5.3 km width did not terminate the rupture propagation of the main shock to the south. Two M>6 earthquakes (the 23 January 2005 and the 18 August 2012) decreased CFS along CS segment and the middle part of DS segment of the 2018 main shock. This implies that the stress release during the previous two earthquakes may have played a vital role in controlling the coseismic slip pattern of the 2018 earthquake.

On 21 May 2021, an Mw 6.1 earthquake, causing considerable seismic damage, occurred in Yangbi County, Yunnan Province of China. To better understand the surface deformation pattern, source characteristics, seismic effect on nearby faults, and strong ground motion, we processed the ascending and descending SAR images using the interferometric synthetic aperture radar (InSAR) technique to capture the radar line-of-sight (LOS) directional and 2.5-dimensional deformation. The source model was inverted from the LOS deformation observations. We further analyzed the Coulomb failure stress (CFS) transfer and peak ground acceleration (PGA) simulation based on the preferred source model. The results suggest that the 2021 Yangbi earthquake was dextral faulting with the maximum slip of 0.9 m on an unknown blind shallow fault, and the total geodetic moment was 1.4 × 10¹⁸ Nm (Mw 6.06). Comprehensive analysis of the CFS transfer and geological tectonics suggests that the Dian–Xibei pull-apart basin is still suffering high seismic hazards. The PGA result demonstrates that the seismic intensity of this event reached up to VIII. The entire process from InSAR deformation to source modeling and strong ground motion simulation suggests that the InSAR technique will play an important role in the assessment of earthquake disasters in the case of the shortening of the SAR imaging interval.