In this study, polysulphone (PSf) membranes were manufactured in different conditions to establish the influence of manufacturing factors on the permeation properties of PSf nanofiltration membranes. PSf membranes were prepared by diffusion-induced phase inversion in N-methyl-pyrrolidone (NMP) as solvent and deionized water as coagulant. The influence of the relative air humidity and casting time of the polymer in the manufacturing process were studied. All the polymeric solutions were prepared at 30 wt% PSf in NMP and a thin film of 250 μm thickness was cast on a support wetted with NMP, to tamp the pores from the support. The influence of these factors on the permeation properties of PSf membranes was investigated in a series of filtration experiments, and by contact angle measurements and SEM observations. The results show an important influence of the relative air humidity and casting time on the permeability properties and reproducibility of the membrane performance.
Y2O3 nanoparticles were used in a polyethersulfone (PES) as additives to increase the permeation properties of the polymeric membranes. Membranes were manufactured by diffusion-induced phase inversion in N-methyl-pyrrolidone (NMP) using a different concentration of nanoparticles. Y2O3 is used in polymeric membranes to enhance their functional properties, especially in wastewater treatment processes. Incorporating Y2O3 nanoparticles into the polymer matrix improves the membrane’s hydrophilicity, permeability, and mechanical strength. Additionally, Y2O3 provides better properties and reduces fouling. Recent studies highlight its potential as a modifying agent for advanced composite membranes. This paper investigated challenges in the synthesis of Y2O3-enhanced membranes and links synthesis with performance. It was observed that the composite membranes have better permeation properties by adding a small amount of Y2O3. For membranes at 21 wt.% PES permeability increase from 107 to 112 L/m2·h/bar. Fouling performance increases by adding nanoparticles, relative flux decreases by 30% for membranes without nanoparticles and by 10% for membranes with nanoparticles, both at a concentration of 25% PES. Rejection increases for membranes at 21%Pes from 21% for membranes without nanoparticles to 39% for membranes with nanoparticles. The influence of Y2O3 nanoparticles on the membranes’ performance was determined by filtration experiments to establish the permeability, fouling, retention, and the water flux; by contact angle to establish the surface hydrophilicity; and by SEM to investigate the membranes’ structures.
12 June 2018 in IOP Conference Series: Materials Science and Engineering
In the past decade, the high demand and strict legislations regarding pure and potable water production and quality require finding new treatment technologies with higher effectiveness. When compared with conventional treatment technologies, membrane technology is a viable option in water and wastewater treatment due to high performance, ease in implementation, cost-efficiency among other advantages, also, leading to a rapid expansion in use in almost all areas of industry. Polymeric ultrafiltration membranes have been successfully used in various industries since 1969, and in later years they were studied in the water purification sector, mainly as a pre-treatment step to reduce severe fouling that could occur in reverse osmosis filtration stage. Polysulfone (PSf) was the polymer of choice in this study with two concentrations, 25 wt.% and 30 wt.%. Surface SEM morphology, roughness and water affinity were analyzed for the studied membranes. Water from Siret river was used in the permeation tests in order to analyze the retention capacity and anti-fouling ability. The present study revealed higher retention for the 30 wt.% PSf membranes, from the physico-chemical and microbiological point-of-view and lower fouling, also.