Energy storage solutions are a vital component of the global transition toward renewable energy sources. The power-to-gas (PtG) concept, which stores surplus renewable energy in the form of methane, has therefore become increasingly relevant in recent years. At present, supported Ni nanoparticles are preferred as industrial catalysts for CO2 methanation due to their low cost and high methane selectivity. However, commercial Ni catalysts are not active enough in CO2 methanation to reach the high CO2 conversion (>99%) required by the specifications for injection in the natural gas grid. Herein we demonstrate the promise of promotion of Ni by Mn, another low-cost base metal, for obtaining very active CO2 methanation catalysts, with results comparable to more expensive precious metal-based catalysts. The origin of this improved performance is revealed by a combined approach of nanoscale characterization, mechanistic study, and density functional theory calculations. Nanoscale characterization with scanning transmission electron microscopy–energy-dispersive X-ray spectroscopy (STEM-EDX) and X-ray absorption spectroscopy shows that NiMn catalysts consist of metallic Ni particles decorated by oxidic Mn2+ species. A mechanistic study combining IR spectroscopy of surface adsorbates, transient kinetic analysis with isotopically labeled CO2, density functional theory calculations, and microkinetics simulations ascertains that the MnO clusters enhance CO2 adsorption and facilitate CO2 activation. A macroscale perspective was achieved by simulating the Ni and NiMn catalytic activity in a Sabatier reactor, which revealed that NiMn catalysts have the potential to meet the demanding PtG catalyst performance requirements and can largely replace the need for expensive and scarce noble metal catalysts.
The use of biomass as a resource for hydrogen production can contribute to the transition towards carbon neutral or carbon negative energy systems. This paper offers a comprehensive investigation of the technical performance and life cycle environmental footprint of three gasification technologies for H2 production, using dry biomass (wood) as input. These are compared with H2 production from reforming of natural gas or biomethane and electrolysis as presented in our previous work. This is followed by an evaluation of the use of H2 as fuel for passenger cars and trucks. The quantity of biomass required for the production of 1 MW H2 is calculated with an integrated process simulation approach on the basis of Aspen Plus simulations and real-plant literature data. We observe that all the technologies analysed provide negative CO2 emissions when coupled with CCS. However, the sorption enhanced reforming and the entrained flow gasifiers are more suited to this scope than the heat pipe reformer, because higher overall CO2 capture rates can be achieved. As CO2 is from biogenic sources, the life cycle carbon footprint of the produced H2 is only slightly positive (without CCS) or negative (with CCS). This negative carbon footprint is not obtained at the cost of important trade-offs with regards to ecosystem quality, human health or resource depletion, with the exception of high forest land use. Fuel cell electric vehicles using hydrogen from biomass (both wood and biomethane) with CCS as fuel turn out to be the most climate friendly among all options, with even possible negative total greenhouse gas emissions. However, limited biomass resources and potential alternative uses need to be considered.
• A new method for the assessment of the water–food–energy nexus is developed. • The quantification of the WFE nexus is operated through an efficiency-type index. • The new index assesses the interrelationship among water and land use and the food production in bioenergy production. • The method is applied to assess the efficiency of biofuel production on the global scale and from the main crops used.