Optically pumped semiconductor disk lasers are an important class of solid state lasers. Despite all their advantages, however, they suffer from heat incorporation into the active region caused by the excess energy of the pump photons. To overcome the limits of common methods in thermal management, we realized a semiconductor membrane external-cavity surface-emitting laser (MECSEL) consisting of a diamond heat spreader sandwiched active region design without a monolithically integrated distributed Bragg reflector (DBR). This diamond-sandwich approach improves the heat dissipation out of the active region and makes generally low-heat conductive DBRs obsolete. In an AlGaInP-based system, we demonstrate 595 mW output power at a wavelength of 657 nm and heatsink temperature of 10°C. The MECSEL enables a variety of new material combinations for new laser wavelengths and further potential for power scaling.
We report on passive mode locking of a semiconductor disk laser emitting pulses shorter than at with a repetition frequency of . A fast saturable absorber mirror fabricated by metal-organic vapor-phase epitaxy in a near-resonant design was used to enable the mode locking operation. It includes two GaInP quantum wells located close to the surface and an additional fused silica coating. The emission spectrum shows the superposition of a soliton-like part and a smaller “continuum” part.
We present a membrane external-cavity surface-emitting laser (MECSEL) operating around 825 nm at room temperature. With a tuning range of 22 nm, the MECSEL fills the spectral gap between 810 nm and 830 nm, and extends the wavelength coverage of this category of high-beam-quality semiconductor lasers. For high-power operation, the pump spot size and cavity mode size can be enlarged in MECSELs. We apply this technique and demonstrate power scaling. The maximum output power is increased from 0.7 W to 1.4 W. Investigations on the beam quality reveal thermal lensing with a marginally changing value close to the diffraction limit.
We studied and compared single-side pumping (SSP) and double-side pumping (DSP) of a semiconductor membrane external-cavity surface-emitting laser (MECSEL). The MECSEL-active region was based on an AlGaAs quantum well structure embedded between two silicon carbide (SiC) wafer pieces that were used as transparent intra-cavity (IC) heat spreaders creating a symmetrical cooling environment. The gain structure targeted emission at 780 nm, a wavelength region that is important for many applications, and where the development of high-brightness high-power laser sources is gaining more momentum. By DSP at 20°C heat sink temperature, we could reduce the laser threshold from 0.79 to 0.69 W of absorbed pump power, while the maximum output power was increased from 3.13 to 3.22 W. The differential efficiency was improved from 31.9% to 34.4%, which represents a record value for SiC-cooled vertically emitting semiconductor lasers. The improvements are enabled by a reduced thermal resistance of the gain element by 9% compared to SSP. The beam quality was measured to be . Finally, we demonstrate a maximum tuning range from 767 to 811 nm. This wavelength range was not addressed by any MECSEL or vertical external-cavity surface-emitting laser device before and extends the available wavelengths for semiconductor based high-quality beam and high-power laser sources to a wavelength window relevant for quantum technology, spectroscopy, or medicine.
We report a distributed Bragg reflector‐free semiconductor disc laser which emits 10 W continuous wave output power at a wavelength of 1007 nm when pumped with 40 W at 808 nm, focused into a 230 μm diameter spot on the gain chip. By introducing a birefringent filter plate in the laser cavity the wavelength could be tuned from 995 to 1020 nm. The laser consisted of a gain chip located at the beam waist of a linear concentric resonator with an output coupling of 2.15%. The gain chip consists of a 1.574‐μm‐thick resonant periodic gain structure, with ten In 0.13 Ga 0.87 As quantum wells embedded in strain‐compensating GaAs 0.94 P 0.06 barrier layers, van der Waals bonded to a silicon carbide intra‐cavity heat spreader.
We report the mode-locked operation of an AlGaInP-based semiconductor disk laser without a saturable absorber. The active region containing 20 GaInP quantum wells is used in a linear cavity with a curved outcoupling mirror. The gain chip is optically pumped by a 532 nm laser, and mode-locking is achieved by carefully adjusting the pump spot size. For a pump power of 6.8 W, an average output power of up to 30 mW is reached at a laser wavelength of 666 nm. The pulsed emission is characterized using a fast oscilloscope and a spectrum analyzer, demonstrating stable single-pulse operation at a repetition rate of 3.5 GHz. Intensity autocorrelation measurements reveal a FWHM pulse duration of 22 ps with an additional coherence peak on top, indicating noise-like pulses. The frequency spectrum, as well as the Gaussian beam profile and the measured beam propagation factor below 1.1, shows no influence of higher order transverse modes contributing to the mode-locked operation.