The crop yield and quality of seven annual forages (four grasses and three legumes) in sole crop and in mixtures (ratio 50:50) for oat (Avena sativa L.), Italian ryegrass (Lolium multiflorum Lam.), triticale (x Triticosecale Wittmack), barley (Hordeum vulgare L.), pea (Pisum sativum L.), berseem (Trifolium alexandrinum L.) and common vetch (Vicia sativa L.) were evaluated in a two-year field experiment adopting two harvesting times, green fodder and silage. The main bio-agronomic traits, dry matter forage yield (DMY) and quantity of crude protein (CP) were determined in both sole crop and intercrop. The land equivalent ratio (LER) was used for evaluating biological efficiency and competitive ability of the intercrops. Our results showed that the total calculated LER for fodder and protein yields was always greater than one and corresponded to crop yield advantages of 16.0% and 11.5%, respectively. Our data also highlighted the low competitive ability of the ryegrass in intercrop, which achieved the lowest yield among all the mixtures. Conversely, the same grass showed the best green fodder quality, due to the high incidence of the legume, equal (on average) to 46%. Triticale and barley, harvested for silage (hard dough stage), provided the best quantitative and qualitative results both in sole crop and intercropped with common vetch and pea, determined mainly by the cereal grain.

Hops (Humulus lupulus L.) constitute a species that grows spontaneously in the region of Calabria (South Italy), but the species’ morphological and genetic characterization have not yet been explored. Thus, we explored some morphological traits related to cones of wild hops from three Calabrian sites: Cosenza (CS), Catanzaro (CZ), and Vibo Valentia (VV). In addition, eight Simple Sequence Repeats (SSR) were adopted to investigate the genetic diversity and population structure of the local germplasm, which were also compared to commercial varieties. Cone length exhibited large variation among the different populations, whereas cone shape was the most discriminant trait according to principal coordinate analysis. Eighty-one alleles were detected with a high mean of alleles per locus (10.12). The SSRs used in the present study were highly informative with a genetic diversity of 0.829 and a PIC value > 0.62, thereby confirming the high genetic variability in Calabria. Finally, genetic structure analysis revealed the existence of two distinct groups regardless of the specimens’ sampling sites. Further studies including other wild hops populations from Calabria will be performed in order to detect specific alleles for new breeding programs.

Over two cropping seasons, 2017/18 and 2018/19, an experimental trial was conducted in a typical cereal-growing environment of the Calabrian hills (southern Italy) to study seeding rate (D) and nitrogen fertilization (N) effects on two barley F1 hybrids (Zoo and Jallon) compared to those of a traditional variety (Lutece), assessing the bio-agronomic response. Barley hybrids, gradually introduced into the principal European countries starting in 2010 as winter forage, currently represent a significant part of the EU internal market. Productive performance was evaluated as grain yield for feed and total biomass for silage and/or biogas production. Research results pointed out the greater performance of barley hybrids compared to conventional varieties in terms of both grain and biomass production. On average, barley hybrids vigour mainly manifested itself through a high tillering and a greater number of ears m⁻² compared to those of the conventional variety (+24 and +23%, respectively). Furthermore, barley hybrids were characterized by a greater 1000-kernel weight and hectolitre weight than those of the Lutece variety (conventional variety). A significant increase in grain production was observed, increasing density from D₁₅₀ to D₂₂₅ rates (+35% and +33%, respectively) which was followed by a decrease in production shifting from D₂₂₅ to D₃₀₀ doses. A significant increase in biomass production was as well highlighted for the two hybrids, shifting from D₁₅₀ to D₂₂₅ rates (+26% and +27%, respectively). The applied nitrogen dose highlighted a different behaviour between the hybrids and the conventional variety; in particular, the lowest nitrogen dose (N₈₀) negatively influenced the Lutece variety both in terms of grain and biomass production (−9% and −16%, respectively) while the hybrids showed the best agronomic response even at the lowest dose. On average, with the N₈₀ dose, grain yield of Zoo and Jallon was greater than 20% and 16%, while with the N₁₂₀ dose grain yield was 9% and 7%, respectively. A similar behaviour was found for biomass yield. It should therefore be emphasized that barley hybrids possess high yielding capacities and that such higher grain production can be achieved in a Mediterranean environment by using a lower seed rate (approximately −25%) and a reduced nitrogen dose (approximately −33%) compared with those commonly applied to conventional varieties.

The cultivation of wheat has been part of the evolution of human civilisation since ancient times. Wheat breeding has modified some of its characteristics to obtain improved varieties with high production potential that better meet the demands of the bread and pasta industry. Even today, there are still old varieties, landraces, adapted to particular environments. They are still cultivated in some areas because of the interest shown by the market in typical bakery products expressing the cultural heritage of local communities. The aim of this work was to evaluate the bio-agronomic and bakery characteristics of four modern genotypes, one old cultivar and two landraces of wheat typically grown in Calabria (Southern Italy). The experiment was carried out over two years in two different locations, during which the main bio-agronomic and quality traits related to bread making aptitude were detected. A marked difference was found between the landraces and the other genotypes in both agronomic and technological characteristics. Despite the higher protein and gluten content, landraces were found to have a significantly lower gluten index.

Lentil (Lens culinaris Medik.) is widely known among grain legumes for its high nutritional quality, playing an important role in enhancing Mediterranean farming systems as a sustainable crop. Field experiments comparing 121 lentil accessions (microsperma and macrosperma types from different countries) were conducted in a semi-arid environment of south Italy over two growing seasons (2016/2017 and 2017/2018). Their agronomic performance was determined, focusing on phenological, morphological, productive, and qualitative variability. Changes in rainfall and temperatures affected the agronomic traits, especially yield components. In both years, the average grain yield (GY) (2.31 and 2.22 t ha⁻¹, respectively) was above the threshold of 2 t ha⁻¹. Consistent yield exceeding the field average in both growing seasons revealed the superiority of accessions from Egypt, Cyprus, Algeria, Nepal, and Tunisia. Moreover, microsperma yielded more (+0.31 and +0.41 t ha⁻¹ in the first and second year, respectively) than macrosperma accessions. Flowering (DASF—days after sowing to flowering) and thousand seed weight (TSW) appeared to be the most important traits related to grain yield. Flowering earliness seems to act as a mechanism for overcoming abiotic stresses. The analysis of yield components revealed a different productive determinism within the two subspecies. As also highlighted by the Principal Component Analysis, microsperma accessions presented on average a significantly higher number of pods per plant (PP) and seeds per pod (SP), despite the considerable variability among countries of origin. The results showed phenological and morphological variability among genotypes, which should be taken into account in view of future selection programs focused on obtaining lentil ideotypes suitable for the Mediterranean environment.

Rye is used in some applications in the food and beverage industry and for the preparation of functional foods. It is an interesting raw material in malting and brewing due to its characteristic contribution to the beer’s color, turbidity, foam and aroma. The aim of this work was to optimize the micro-malting process of a rye landrace. The response surface methodology (RSM) was applied to study the influence of three malting parameters (germination time, germination temperature and degree of steeping) on the quality traits of malted rye. Long germination times at high temperatures resulted in an increase in the extract and Kolbach index. The model for the apparent attenuation limit showed a particular pattern, whereby time and temperature inversely influenced the response. The lowest viscosities were determined in the worts produced from highly modified malts. Optimization of the variables under study was achieved by means of a desirability function and a genetic algorithm. The two methodologies provided similar results. The best combination of parameters to optimize the malting process on the rye landrace under study was achieved at 6 days, 12 °C and 44 g/100 g.