Appropriate selection and well-timed measurement of plant developmental, morphological and physiological parameters are essential to maximize efficacy and minimize time consumption of experiments. To select for the most sensitive indicators of drought or salt stress, three independent pot experiments with diverse setups were analysed with 20–20 measured parameters. Parameters of plant growth, phenology and symbiotic interactions, visual stress symptoms, photosynthetic activity, nutrient composition and vitality were studied and the result matrices were evaluated with principal component analysis (PCA). Stress effects manifested in PC1 of two experiments and in PC2 of the third one. Traits assumed to be adequate for stress indication were characterized by high PC1 or PC2 loading values. Beside parameters of biomass production, growth and visible stress symptoms, less evident traits e.g. root electrical capacitance, membrane stability index in roots and leaves, relative water content of leaves and SPAD units were identified.

This study was carried out to determine the effect of arsenic on tomato and cabbage cultivated in sand, sandy silt, and silt soil, and irrigated with water containing arsenic at concentrations 0.05 and 0.2 mg/L. Increasing arsenic in irrigation water did not affect the photosynthetic machinery. The chlorophyll content index increased in case of all soils and was dependent on the soil nitrogen, phosphorous, and plant biomass. Arsenic concentrations of 0.05 and 0.2 mg/L did not display any phytotoxic symptoms other than reduction in biomass in some cases. In cabbage, arsenic treatment of 0.2 mg/L increased the overall plant biomass production, while in tomato there was a decrease in aerial part and fruit biomass. The biomass production of both plants treated with different concentrations of arsenic, in the three soils was in the following order: silt > sand > sandy silt. Increase of arsenic in the irrigation water resulted in increase in arsenic concentration in the root and aerial part of both plants, at the same cultivation parameters. But tomato fruits displayed a decrease in arsenic accumulation with higher arsenic treatment. In both plants, the arsenic concentration in the plant parts changed in the following order: root > aerial part > fruit. Cabbage accumulated approximately twenty-fold more arsenic in the edible part (0.10-0.25 mg/kg DW) as compared to tomato (0.006-0.011 mg/kg DW) and displayed a good correlation with soil extractable arsenic. When cabbage was cultivated in three different soils applying the same irrigation water, it accumulated arsenic in the following order: sand > sandy silt > silt (p < 0.001 at 0.05 mg/L and p < 0.01 at 0.2 mg/L arsenic treatment). In tomato, the difference in arsenic accumulation among different soil types was highly significant (p < 0.001) but the accumulation pattern varied with the arsenic treatment applied. Sandy soil with the lowest total soil arsenic (4.32 mg/kg) resulted in the highest arsenic concentration in both plants. Among all soils and plants, the transfer factors and bioaccumulation factors were higher in sandy soil, and in cabbage. The estimated daily intake and hazard quotient values for arsenic were lower than 1 in all cases, implying no non-cancerous health risks at the arsenic concentrations applied in our study. Among nutrients only P showed a slight decline with increasing arsenic concentration while all other elements (Mg, K, Ca, S, Si, Fe, Mn, Cu, Zn) did not display any significant changes.

Soil enhancements such as biochar (BC) are gaining attention as tools to mitigate climate change and also to promote crop growth. However, biochar use can disrupt soil ecosystems by changing the soil’s physical, chemical, and biological properties. The study aimed to determine how biochar influences soil physical changes such as specific surface area (SSA) and water vapor sorption, and how these conditions affect arbuscular mycorrhizal fungal (AMF) hyphae growth and glomalin production. The study analyzed these factors at different plant phenological phases (i.e., flowering, development of fruit, and ripening of fruit and seed) to better understand the changes within the system while varying biochar amounts. The study also investigated the effect of different soil physical and chemical parameters on mycorrhizal hyphae growth and glomalin production. Four treatments were investigated: 0, 0.5%, 2.5%, and 5.0% (w/w) biochar amended silt loam soil planted with pepper. Soil samples were taken at the beginning and weeks 6, 10, and 12 of the study. The amount of adsorbed water vapor increased with an increasing amount of biochar added to the soils. Compared to control, SSA was significantly higher in all biochar amended treatments based on adsorption data, and only in the highest biochar amended soils for the desorption data at the end of the experiment. The presence of AMF in the roots appeared at week 6 of the experiment and the intensity of AMF root colonization increased with the age of plants. The AMF colonization parameters were significantly lower in BC2.5 compared to all other biochar amended soils. The abundance of intraradical AMF structures was highly correlated with several physicochemical soil parameters, such as SSA, the geometric mean diameter of soil aggregate, soil aggregate sizes, or pH. Glomalin production was negatively correlated with SSA, water vapor adsorption, aggregate stability, aggregate size, total nitrogen, potassium, and organic carbon content of the soil, while positive correlation was observed with bulk density. Increased biochar amount resulted in a significant decrease in glomalin production, concurrent with the age of the plants. Our results highlight the great complexity of interactions between soil physicochemical and biological parameters, and the importance of the time of sampling when biochar is used in soil, as the effects of biochar additions on the plant, soil physical characteristics, and soil microsymbionts vary over time.

Background: The measurement of root dielectric response is a useful non-destructive method to evaluate root growth and function. Previous studies tracked root development throughout the plant growing cycle by single-time electrical measurements taken repeatedly. However, it is known that root conductivity and uptake activity can change rapidly, coupled with the day/night cycles of photosynthetic and transpiration rate. Therefore, the low-frequency dielectric monitoring of intact root–substrate systems at minute-scale temporal resolution was tested using a customized impedance measurement system in a laboratory environment. Electrical capacitance (C_R) and conductance (G_R) and the dissipation factor (D_R) were detected for 144 h in potted maize, cucumber and pea grown under various light/dark and temperature conditions, or subjected to progressive leaf excision or decapitation. Photosynthetic parameters and stomatal conductance were also measured to evaluate the stress response. Results: The C_R and G_R data series showed significant 24-h seasonality associated with the light/dark and temperature cycles applied. This was attributed to the diurnal patterns in whole-plant transpiration (detected via stomatal conductance), which is strongly linked to the root water uptake rate. C_R and G_R decreased during the 6-day dark treatment, and dropped proportionally with increasing defoliation levels, likely due to the loss of canopy transpiration caused by dark-induced senescence or removal of leaves. D_R showed a decreasing trend for plants exposed to 6-day darkness, whereas it was increased markedly by decapitation, indicating altered root membrane structure and permeability, and a modified ratio of apoplastic to cell-to-cell water and current pathways. Conclusions: Dynamic, in situ impedance measurement of the intact root system was an efficient way of following integrated root water uptake, including diurnal cycles, and stress-induced changes. It was also demonstrated that the dielectric response mainly originated from root tissue polarization and current conduction, and was influenced by the actual physiological activity of the root system. Dielectric measurement on fine timescale, as a diagnostic tool for monitoring root physiological status and environmental response, deserves future attention.

The characterization of mycorrhizal status in hosts can be a good indicator of symbiotic associations in inoculation experiments or in ecological research. The most common microscopic-based observation methods, such as (i) the gridline intersect method, (ii) the magnified intersections method and (iii) the five-class system of Trouvelot were tested to find the most simple, easily executable, effective and objective ones and their appropriate parameters for characterization of mycorrhizal status. In a pot experiment, white clover (Trifolium repens L.) host plant was inoculated with 6 (BEG144; syn. Rhizophagus intradices) in pumice substrate to monitor the AMF colonization properties during host growth. Eleven (seven classical and four new) colonization parameters were estimated by three researchers in twelve sampling times during plant growth. Variations among methods, observers, parallels, or individual plants were determined and analysed to select the most appropriate parameters and sampling times for monitoring. The comparability of the parameters of the three methods was also tested. As a result of the experiment classical parameters were selected for hyphal colonization: colonization frequency in the first stage or colonization density in the later period, and arbuscular richness of roots. A new parameter was recommended to determine vesicule and spore content of colonized roots at later stages of symbiosis.

The short-term effects of processed waste materials: sewage sludge compost (up to 0.5%), biochar made of paper sludge and grain husk (BC) (up to 2%) combined with plant growth-promoting rhizobacterial (PGPR) inoculum, on the fertility of acidic sandy soil at 65% of field capacity were tested in a pot experiment in separate and combined treatments. The soil pH, organic matter content, total and plant-available nutrients, substrate-induced respiration, arbuscular mycorrhizal fungal (AMF) root colonisation parameters and maize (Zea mays L.) biomass were investigated in experiments lasting two months. The positive priming (21% organic matter loss) induced by BC alone was not observed after combined application. The combination of compost and PGPR with 1.5% BC resulted in 35% higher P and K availability due to greater microbial activity compared to BC alone. Only compost applied alone at 0.5% gave a 2.7 times increase in maize biomass. The highest microbial activity and lowest AMF colonisation were found in combined treatments. In the short term the combined application of BC, compost and PGPR did not result in higher fertility on the investigated soil. Further research is needed with a wider range of combined treatments on acidic sandy soil for better understanding of the process.