This work adopted a strategy to use new functional high-performance piezoelectric materials for sustainable energy production in wearable self-powered electrical devices. An innovative modification in electrospinning was used to produce highly aligned nanofibers. In the nanogenerator, the flexible membrane constituents were tunefully combined. The novel composite nanofibers were made of Poly (vinylidene fluoride) PVDF, loaded with ZnO@ZnS core–shell nanoparticles to achieve a non-brittle performance of the hetero nanoparticles and piezoelectric polymer. A nanofiber mat was inserted between two thermoplastic sheets with conductive electrodes for application in wearable electronic devices. Complete spectroscopic analyses were performed to characterize the nanofiber’s material composition. It is shown that the addition of 10 wt % ZnO@ZnS core–shell nanoparticles significantly improved the piezoelectric properties of the nanofibers and simultaneously kept them flexible due to the exceedingly resilient nature of the composite. The superior performance of the piezoelectric parameter of the nanofibrous mats was due to the crystallinity (polar β phase) and surface topography of the mat. The conversion sensitivity of the PVDF device recorded almost 0.091 V/N·mm3, while that of the PVDF—10 wt % ZnO@ZnS composite mat recorded a sensitivity of 0.153 V/N·mm3, which is higher than many flexible nano-generators. These nanogenerators provide a simple, efficient, and cost-effective solution to microelectronic wearable devices.
The appropriate ventilation for factory spaces with regard to volume flow rate and air velocity inside the factory is one of the most important factors in the improvement of the thermal comfort of workers and in the reduction of the percentage of pollution they are exposed to, which in turn helps to improve the work environment and increase productivity. It also could improve the performance of machines. Hence, overheating can cause various problems and malfunctions. In this study, three types of mechanical ventilation systems are compared: the wall fan extract ventilation system, the roof fan extract ventilation system, and the spot cooling system. The Ansys software has been used to conduct the computational fluid dynamics (CFD) simulations for the different cases and the ventilation effectiveness factor (VEF) has been used to compare the performances of the three systems. The ventilation factor notably relies on the temperature distribution produced through the modeling and the results show that the most optimal system that can be used for similar factory spaces is the forced ventilation system. Finally, it is also the best in terms of energy consumption, despite the increase in the initial cost of its installation.
Cooling of Electronic equipment’s is an attractiveresearch area in engineering applications. Continuedminimization of electronic system has resulted in dramaticincrease in the amount of heat generated per unit volume, Theaim of this study is to use computational Fluid Dynamics inorder to draw a CFD model for forced cooling conjugate heattransfer analyses in heat generating electronic systems andcompare between a collection of actual commercial heat sinksdifferent from in geometry ,material , and number of fins .Acomplete computer chassis model with heat sinks and fansinside was created and parametric analyses were performed tocompare the effects of different turbulence models, meshresolutions, and radiative heat transfer. The CFD software wasused, ANSYS Icepack 18.0 for preprocessing and fluent forsolution and post processing. The road map was applied to fivedifferent heat sinks and another three heat sink as a validationmodeled into the full chassis. Numerical results were comparedwith the available experimental data and they were in goodagreement.