Despite the significant advancements in geomodelling techniques over the past few decades, it is still quite challenging to obtain accurate assessments of hydraulic fracture propagation. This work investigates the effect of fluid leak-off in a dual-porosity system on the hydraulic fracture propagation geometry, which, in turn, affects hydrocarbon recovery from tight and unconventional reservoirs. Fracture propagation within tight reservoirs was analyzed using the Pseudo Three-Dimensional-Carter II model for single- (P3D-C) and dual-porosity systems (P3D-C-DP). Previous studies have accounted for leak-off in single-porosity models; however, studies within dual-porosity systems are still quite limited. We present a novel approach to coupling fluid leak-off in a dual-porosity system along with a fracture-height growth mechanism. Our findings provide important insights into the complexities within hydraulic fracturing treatment design using our new and pragmatic modeling approach. The simulation results illustrate that fluid leak-off in dual-porosity systems contributes to a confined fracture half-length ($x_f)$, that is 31% smaller using the P3D-C-DP model as opposed to the single-porosity model (P3D-C). As for the fracture height growth ($h_f)$, the P3D-C-DP model resulted in a 40% shorter fracture height compared to the single-porosity model.

Low salinity waterflooding (LSW) has shown promising results in terms of increasing oil recovery at laboratory scale. In this work, we study the LSW effect, at laboratory scale, and provide a basis for quantifying the effect at field scale by extracting reliable relative permeability curves. These were achieved by experimental and numerical interpretation of laboratory core studies. Carbonate rock samples were used to conduct secondary and tertiary unsteady-state coreflooding experiments at reservoir conditions. A mathematical model was developed as a research tool to interpret and further validate the physical plausibility of the coreflooding experiments. At core scale and a typical field rate of ~1 ft/day, low salinity water (LS) resulted in not only ~20% higher oil recovery compared to formation water (FW) but also recovered oil sooner. LS water also showed capability of reducing the residual oil saturation when flooded in tertiary mode. The greater oil recovery caused by LSW can be attributed to altering the wettability of the rock to less oil-wet as confirmed by the numerically extracted relative permeability curves.

Use of nanoparticles as a method for enhancing oil recoveries has become an attractive prospect. Experimental evidence has shown that this technique possesses the ability to improve recoveries via wettability alteration and interfacial tension reduction amongst other strategies. In this study, we analyze the potential of nanoparticles employed in coreflood experiments. Low concentration acid was added to aid in the dispersion of the nanoparticles in the brine by protecting them from being aggregated, while enhancing the stimulation of the tight porous media. Electrokinetics was also implemented following a sequential as well as a simultaneous approach to further stimulate the fluids injected, controlling their mobility, and therefore, increasing the depth of penetration within the porous media. Several coreflood experiments were carried out on highly heterogeneous carbonate samples of Middle Eastern origin with permeabilities of around 0.1 mD. Zeta potential measurements were conducted on the inlet side of the preserved core-plugs after the conclusion of each coreflood. The findings indicated a close connection between the rate of wettability alteration observed over the duration of nano-acid fluid injection and mode of electrokinetic application. The best performing nano-acid fluids correlated with the highest shift in the magnitude of the zeta potential across all tested strategies. Results show that oil recovered via this hybrid technique was mostly 10–15% higher than that derived when only smart brine was employed.

Carbonated water has proven advantages over conventional CO₂ injection in terms of arresting free CO₂ mobility, low-pressure injection, lower volume requirement, and higher efficiency. The term “engineered water” is designated to selective ion-spiked injection water with the advantage of the ion-exchange reactions with the rock minerals and releasing trapped oil. This article investigated the synergic effect of dissolved CO₂ and engineered water for oil recovery and understanding inner mechanisms. Recovery efficiencies were evaluated through coreflood studies, which revealed that the hybrid water could recover 6–10% more oil than engineered water and about 3% more than carbonated water. HP-HT pendant-drop studies show the insignificance of IFT reduction. Wettability change from oil wet to near-water wet is attributed as a significant factor. The dissolution of Ca²⁺ and Mg²⁺ and deposition of SO₄²⁻ observed in coreflooding may have a significant contribution to oil recovery. Pore enlargement evidenced in NMR-PSD and NMR-ICP results support this claim. The study confirmed that the EWI-CWI hybrid technique could be a promising EOR method, eliminating the requirement for high-pressure injection, the problems of gravity segregation, and the early breakthrough of CO₂. It can also be an effective EOR solution, providing a significant cost advantage and higher oil recovery in addition to the environmental benefits of CO₂ sequestration.

Augmented by recent activities in the oil and gas industry, it can be seen that an economical and efficient hydraulic fracturing job has become critical for the successful development of unconventional reservoirs. However, exploitation of unconventional reservoirs is heavily water-intensive as compared to conventional reservoirs. Given this concern, it is essential to reform how