We have investigated radiation induced absorption in Al-doped, P-doped and Ge-doped optical fibres under 60Co source gamma-radiation up to a total dose of 71 kGy at two temperatures 30 and 80 °C. The Al-doped and P-doped fibres demonstrated high radiation sensitivity required for the optical fibre dosimetry. The RIA response to temperature increase from 30 to 80 °C depended on the dopant. In Al-doped fibres the absorption level decreased by 25% whereas in P-doped fibres it increased by at least 10%. For comparison we also tested standard telecom-grade Ge-doped fibres. Such fibres demonstrated a monotonous rise of the RIA during the whole irradiation with a small decrease of sensitivity at the higher temperature.
We report the interpulse dynamics in fiber soliton laser because of depletion and relaxation of gain and absorption. The soliton interaction range is shown to depend largely on the relaxation time of dissipative parameters while the compensation of the dynamical gain and absorption depletion leads to the formation of stationary soliton groups with unequal interpulse distances.
Moving differential and dynamic window moving averaging are simple and well-known signal processing algorithms. However, the most common methods of obtaining sufficient signal-to-noise ratios in distributed acoustic sensing use expensive and precise equipment such as laser sources, photoreceivers, etc., and neural network postprocessing, which results in an unacceptable price of an acoustic monitoring system for potential customers. This paper presents the distributed fiber-optic acoustic sensors data processing and noise suppression techniques applied both to raw data (spatial and temporal amplitude distributions) and to spectra obtained after the Fourier transform. The performance of algorithms’ individual parts in processing distributed acoustic sensor’s data obtained in laboratory conditions for an optical fiber subjected to various dynamic impact events is studied. A comparative analysis of these parts’ efficiency was carried out, and for each type of impact event, the most beneficial combinations were identified. The feasibility of existing noise reduction techniques performance improvement is proposed and tested. Presented algorithms are undemanding for computation resources and provide the signal-to-noise ratio enhancement of up to 13.1 dB. Thus, they can be useful in areas requiring the distributed acoustic monitoring systems’ cost reduction as maintaining acceptable performance while allowing the use of cheaper hardware.
We report a simple technical solution for precise adjustment of short fiber cavities commonly used with Brillouin fiber lasers. The technique is based on recording the Brillouin response of the cavity to the frequency scanned laser radiation. The recorded traces are used to calculate the excess cavity length that needs to be removed from the original cavity to provide its precise adjustment to the Brillouin resonance at any preselected pump laser wavelength. The adjusted laser cavity is simultaneously resonant for pump and Stokes radiation. For demonstration of the approach, fine adjustment of a 4 m long ring cavity based on standard Corning SMF-28 fiber is performed.