The paper develops a statistical model for the signals received in phase-sensitive optical time domain reflectometry (OTDR) probed by highly coherent sources. The backscattering process is modelled by a set of discrete scatterers with properly chosen parameters. Explicit equations for calculating the amplitude and the phase of the backscattered signal are obtained. The developed model predicts spectral and autocorrelation characteristics of the amplitude signals that are validated by experimental results. Characteristics of the phase signals, practicable for studying the sensing applications of the OTDR system, are presented and studied as well, demonstrating good correspondence with experiment. A more detailed modelling of distributed vibration sensing systems and their response to disturbances along an optical fiber will be possible as an extension of the developed formalism.
We have investigated radiation induced absorption in Al-doped, P-doped and Ge-doped optical fibres under 60Co source gamma-radiation up to a total dose of 71 kGy at two temperatures 30 and 80 °C. The Al-doped and P-doped fibres demonstrated high radiation sensitivity required for the optical fibre dosimetry. The RIA response to temperature increase from 30 to 80 °C depended on the dopant. In Al-doped fibres the absorption level decreased by 25% whereas in P-doped fibres it increased by at least 10%. For comparison we also tested standard telecom-grade Ge-doped fibres. Such fibres demonstrated a monotonous rise of the RIA during the whole irradiation with a small decrease of sensitivity at the higher temperature.
The paper presents an approach to noninvasively measure pulse wave delay and velocity by means of two multiplexed fiber-optic Fabry-Perot interferometric sensors interrogated by means of spectral interferometry. The pulse wave signals were measured with 1 kHz sampling rate. The obtained optical path difference resolutions are on the order of tens picometers, which allowed the pulse wave signal features as small as 100 pm to be clearly observed in the demodulated waveforms. The pulse wave velocity between different arteries was measured, demonstrating good agreement with the known data, where applicable. The paper also presents a mathematical model based on Cramer-Rao approach, describing the fundamental resolution limits of the pulse wave delay measurement. The derived mathematical model is not limited to fiber-optic pulse wave sensors and can be used for estimating the performance of other systems, such as photoplethysmographic and ultrasound. The reported work paves the way to development of novel all-optical non-invasive systems for medical diagnostics and vital signs monitoring, including portable devices.
The factors limiting the resolution of displacement sensors based on the extrinsic Fabry–Perot interferometer were studied. An analytical model giving the dependency of extrinsic Fabry–Perot interferometric (EFPI) resolution on the parameters of an optical setup and a sensor interrogator was developed. The proposed model enables one to either estimate the limit of possible resolution achievable with a given setup, or derive the requirements for optical elements and/or a sensor interrogator necessary for attaining the desired sensor resolution. An experiment supporting the analytical derivations was performed, demonstrating a large dynamic measurement range (with cavity length from tens of microns to 5 mm), a high baseline resolution (from 14 pm), and good agreement with the model.