Modeling the fuel injection process in modern gasoline direct injection engines plays a principal role in characterizing the in–cylinder mixture formation and subsequent combustion process. Flash boiling, which usually occurs when the fuel is injected into an ambient pressure below the saturation pressure of the liquid, is characterized by fast breakup and evaporation rates but could lead to undesired behaviors such as spray collapse, which significantly effects the mixture preparation. Four mono–component fuels have been used in this study with the aim of achieving various flashing behaviors utilizing the Spray G injector from the Engine Combustion Network (ECN). The numerical framework was based on a Lagrangian approach and was first validated for the baseline G1 condition. The model was compared with experimental vapor and liquid penetrations, axial gas velocity, droplet sizes and spray morphology and was then extended to the flash boiling condition for iso–octane, n–heptane, n–hexane, and n–pentane. A good agreement was achieved for most of the fuels in terms of spray development and shape, although the computed spray morphology of pentane was not able to capture the spray collapse. Overall, the adopted methodology is promising and can be used for engine combustion modeling with conventional and alternative fuels.
The selective catalytic reduction (SCR) is a technology employed for NOx reduction purposes which is based on the injection of an Urea Water Solution (UWS) into the exhaust line. Conversion of this injected urea into ammonia is a key step to ensure high SCR efficiency. In order to study this phenomenon, a three-dimensional model of the urea–water injection process has been created to recreate realistic conditions. A Lagrangian–Eulerian approach has been followed to model liquid and gas phases, respectively. Droplet evaporation as well as relevant chemical processes have been included to recreate the thermolysis and hydrolysis phenomena, and the results have been validated against literature data. Then, the validated model has been applied to recreate an in-house experimental facility that measured spray macroscopic and microscopic characteristics by means of diffused back illumination (DBI) visualization. Probability density functions of the UWS droplet sizes as well as the velocity distributions have been obtained at three different regions of interest to be compared with the experimental data set. Contours of isocyanic acid and ammonia mass fractions have been included to show the chemical transformation from urea into its products. The model accurately replicates the experimental results, and it stands as a good methodology to predict the main spray characteristics as well as the chemical processes that take place in actual SCR systems.