Anwer S. Abd El-Hameed

Prof. Dr. Anwer S. Abd El-Hameed

Microstrip department, Electronics Research Institute, Giza, Al Jīzah, Egypt
orcid

Research Focus & Metrics

Academic Career Length

14Years (2013-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 October 2017 in IEEE Antennas and Wireless Propagation Letters
Verified
Journal Article
Closed access
AAAhmad Abdalrazik
Ahmad Abdalrazik
Anwer S. Abd El-HameedAnwer S. Abd El-Hameed
Anwer S. Abd El-Hameed
AAAdel B. Abdel-Rahman
Adel B. Abdel-Rahman
In this letter, we propose a three-port multiple-input-multiple-output (MIMO) dielectric resonator antenna using three mutually decoupled and near-degenerate modes for X-band applications. To achieve decoupling, two of the three excited modes are chosen such that there is low mutual spatial overlapping between their field magnitudes; then, a third mode is imposed such that its field components are perpendicular to the other two modes. The impedance bandwidths of the three ports are 880 MHz, 870 MHz, and 2.61 GHZ, respectively, where contiguous bandwidth for the third port is achieved by utilizing the overlap of two resonances of TE 2δ1 y mode. The proposed antenna could be used either as a three-port MIMO antenna with operating bandwidth of 720 MHz, or as a two-port MIMO antenna with operating bandwidth of 880 MHz, at center frequency of 9.48 GHz. The gains of the three patterns at center frequency are 8.1 dB, 7.5 dB, and 7.4 dB, respectively.

15 August 2017 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
Anwer S. Abd El-HameedAnwer S. Abd El-Hameed
Anwer S. Abd El-Hameed
ABAdel Barakat
Adel Barakat
AAAdel B. Abdel-Rahman
Adel B. Abdel-Rahman
AAAhmed Allam
Ahmed Allam
RPRamesh Pokharel
Ramesh Pokharel
This letter presents a 60-GHz ultracompact on-chip bandpass filter (BPF). The designed filter is based on a unique structure, which consists of two overlapped broadside-coupled open-loop resonators, achieving a high level of miniaturization. Moreover, each resonator is loaded by a metal-insulator-metal capacitor to get further miniaturization. Defected ground structure pattern is constructed under the filter structure to enhance the insertion loss (IL). This BPF is designed and fabricated using a standard 0.18-μm complementary metal-oxide-semiconductor technology for millimeter-wave applications. The fabricated BPF chip size is 240 × 225 μm 2 including pads. The measured results agree well with the simulation ones and show that the BPF has an IL of 3.3 dB at 59.5-GHz center frequency, and a bandwidth of 12.9 GHz.

10 December 2021 in IEEE Access
Verified
Journal Article
Open access
RERania R. Elsharkawy
Rania R. Elsharkawy
Anwer S. Abd El-HameedAnwer S. Abd El-Hameed
Anwer S. Abd El-Hameed
SEShaza El-Nady
Shaza El-Nady
A quad-port multiple-input multiple-output (MIMO) filtenna with compact dimensions of $50\times50$ mm 2 is arranged. In this MIMO filtenna, each element is placed orthogonal to its adjacent one to enhance the isolation. The MIMO element is configured based on the novel COVID-19 virus shape with a co-planar waveguide (CPW) feeding structure and dimensions of $17\times22$ mm 2 . The element bandwidth ranges from 3.3 GHz to more than 60 GHz. Three frequency notches are designed at 3.5 GHz for WiMAX, 5.5 GHz for WLAN, and 8.5 GHz for X-band applications. A bandpass filter (BPF) with high out-of-band rejection is used as a decoupling structure (DS) to improve the isolation to more than 30 dB across most of the bandwidth. The BPF is designed based on LC lumped elements, and then implemented using planar strip lines. The proposed MIMO filtenna system provides an impedance bandwidth of 2.4–18 GHz, a peak gain of 5 dBi, and an envelope correlation coefficient (ECC) less than 0.00021. In turn, channel capacity loss does not exceed 0.2. The MIMO filtenna is fabricated and measured showing a good agreement between the measured and simulated results.

24 October 2018 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
Anwer S. Abd El-HameedAnwer S. Abd El-Hameed
Anwer S. Abd El-Hameed
ABAdel Barakat
Adel Barakat
AAAdel B. Abdel-Rahman
Adel B. Abdel-Rahman
AAAhmed Allam
Ahmed Allam
RPRamesh Pokharel
Ramesh Pokharel
This paper presents a new type of a low-loss miniaturized coplanar-waveguide (CPW) transmission line (TL) by employing distributed loading, capacitors and inductors, in 0.18-μm complementary metal-oxide-semiconductor (CMOS) technology. The capacitors are realized by vertical parallel plates made of vias, and a group of open stubs inserted to the signal line, whereas the inductors are realized by high impedance lines. Then, the proposed CPW-TL is employed to design a miniaturized millimeter wave ultra-wideband low-loss Wilkinson power divider/combiner (WPD/C). The proposed distributed loading results in reducing each WPD/C arm length by more than 50% without changing its characteristic impedance and insertion loss (IL). The design is fabricated in 0.18-μm CMOS technology and tested. The measured results show a wideband performance from dc to 67 GHz with 1-dB IL and isolation greater than 15 dB from 36 to 67 GHz. In addition, the fabricated WPD/C achieves an excellent amplitude imbalance and phase imbalance of less than 0.16 dB and 0.45°, respectively. The core chip size is 336 × 165 μm 2 , which is almost 32.8% compact compared to the recently proposed WPD in the same technology.

26 June 2019 in AEU - International Journal of Electronics and Communications
Verified
Journal Article
Closed access
Anwer S. Abd El-HameedAnwer S. Abd El-Hameed
Anwer S. Abd El-Hameed
MWM.G. Wahab
M.G. Wahab
Ayman ElboushiAyman Elboushi
Ayman Elboushi
MEMarwa S. Elpeltagy
Marwa S. Elpeltagy

31 May 2019 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
RSRamy Sharaf
Ramy Sharaf
AAAdel B. Abdel-Rahman
Adel B. Abdel-Rahman
Anwer S. Abd El-HameedAnwer S. Abd El-Hameed
Anwer S. Abd El-Hameed
ABAdel Barakat
Adel Barakat
SHSherif Hekal
Sherif Hekal
AAAhmed Allam
Ahmed Allam
This letter presents a new compact dual-band wireless power transfer (DB-WPT) system. The proposed system is based on two individual transmitting (TX) and receiving (RX) structures. Each structure consists of two interlaced resonators to achieve compact size. A single microstrip line loaded by a surface mounted capacitor (SMD) is used for power feeding. Moreover, high miniaturization of the TX/RX structures is achieved by SMD capacitor loading. In the proposed DB-WPT system, power is transferred from/to the source/load through electromagnetic resonant coupling between the TX and the RX structures. An equivalent circuit of the proposed DB-WPT system is extracted, and then the optimized structures are fabricated and measured. The measured results are in good agreement with the simulated ones. The proposed DB-WPT system has a peak efficiency of 80% and 73% at a transmission distance of 17 mm for frequency 300 and 675 MHz, respectively.