Background: The biosynthesis of silver nanoparticles (AgNPs) is an area of interest for researchers due to its eco-friendly approach. The use of biological approaches provides a clean and promising alternative process for the synthesis of AgNPs. We used for the first time the supernatant of Leclercia adecarboxylata THHM under optimal conditions to produce AgNPs with an acceptable antimicrobial activity against important clinical pathogens. Results: In this study, soil bacteria from different locations were isolated and screened for their potential to form AgNPs. The selected isolate, which was found to have the ability to biosynthesize AgNPs, was identified by molecular methods as Leclercia adecarboxylata THHM and its 16S rRNA gene was deposited in GenBank under the accession number OK605882. Different conditions were screened for the maximum production of AgNPs by the selected bacteria. Five independent variables were investigated through optimizations using one variable at a time (OVAT) and the Plackett–Burman experimental design (PBD). The overall optimal parameters for enhancing the biosynthesis of AgNPs using the supernatant of Leclercia adecarboxylata THHM as a novel organism were at an incubation time of 72.0 h, a concentration of 1.5 mM silver nitrate, a temperature of 40.0 °C, a pH of 7.0, and a supernatant concentration of 30% (v/v) under illumination conditions. The biosynthesized AgNPs have been characterized by UV–visible spectroscopy (UV–Vis), transmission electron microscopy (TEM), and Fourier transform infrared spectroscopy (FTIR). The biosynthesized AgNPs showed an absorption peak at 423 nm, spherical shape, and an average particle size of 17.43 nm. FTIR shows the bands at 3321.50, 2160.15, and 1636.33 cm⁻¹ corresponding to the binding vibrations of amine, alkyne nitrile, and primary amine bands, respectively. The biosynthesized AgNPs showed antimicrobial activity against a variety of microbial pathogens of medical importance. Using resazurin-based microtiter dilution, the minimum inhibitory concentration (MIC) values for AgNPs were 500 µg/mL for all microbial pathogens except for Klebsiella pneumoniae ATCC13883, which has a higher MIC value of 1000 µg/mL. Conclusions: The obtained data revealed the successful green production of AgNPs using the supernatant of Leclercia adecarboxylata THHM that can be effectively used as an antimicrobial agent against most human pathogenic microbes.

κ-carrageenan is useful for its superior gelling, hydrogel, and thickening properties. The purpose of the study was to maximize the hydrogel properties and water-absorbing capacity of κ-carrageenan by blending it with starch from potato peels to be used as safe and biodegradable water-absorbent children’s toys. The prepared materials were analyzed using FTIR and Raman spectroscopy to analyze the functional groups. Results showed that there was a shift in the characteristic peaks of starch and κ-carrageenan, which indicated their proper reaction during blend formation. In addition, samples show a peak at 1220 cm⁻¹ corresponding to the ester sulfate groups, and at 1670 cm⁻¹ due to the carbonyl group contained in D-galactose. SEM micrographs showed the presence of rough surface topology after blending the two polymers, with the appearance of small pores. In addition, the presence of surface cracks indicates the biodegradability of the prepared membranes that would result after enzymatic treatment. These results are supported by surface roughness results that show the surface of the κ-carrageenan/starch membranes became rougher after enzymatic treatment. The hydrophilicity of the prepared membranes was evaluated from contact angle (CA) measurements and the swelling ratio. The swelling ratio of the prepared membranes increased gradually as the starch ratio increased, reaching 150%, while the water-uptake capacity increased from 48 ± 4% for plain κ-carrageenan to 150 ± 5% for 1:2 κ-carrageenan/starch blends. The amylase enzyme showed an effective ability to degrade both the plain κ-carrageenan and κ-carrageenan/starch membranes, and release glucose units for up to 236 and 563, respectively. According to these results, these blends could be effectively used in making safe and biodegradable molded toys with superior water-absorbing capabilities.

Bioethanol-derived biomass is a green sustainable source of energy that is highly recommended as an efficient alternative to the replacement of fossil fuels. However, this type of bioethanol production is always expensive with very low bioethanol concentration. Therefore, this work aims to represent a facile and green approach for bioethanol production with high concentration and purity as well as reasonable cost from corn stover (CS). The goal of this study is to characterize CS and its treated samples with maleic acid (CSM) using various characterization analyses, such as proximate and ultimate analysis, HHV, TGA, FTIR, SEM, and CHNS. The bioethanol production stages: Pretreatment, enzymatic degradation, fermentation, and finally bioethanol separation and purification via the pervaporation process, which have been investigated and optimized are associated with the economic analysis. The optimum operating condition of the pretreatment process was 2% maleic acid, 1:20 solid-to-liquid ratio at 45 psi, 120 °C, and 1 h of operation in the autoclave. This process contributes to 53 and 45% lignin and hemicellulose removal, 98% cellulose recovery, and a glucose yield of 741 mg/dL. The yeast isolate succeeded in the production of 1230 mg/dL of bioethanol. This isolated yeast strain was close to Pichia nakasei with a similarity of 98%, and its amplified 18S rRNA gene sequence was deposited in GenBank with the accession number MZ675535. Poly (MMA-co-MA) membrane was synthesized, characterized, and its efficiency for increasing the bioethanol concentration was evaluated using the integrated pervaporation technique. The techno-economic analysis is presented in detail to evaluate the process profitability, which achieves a considerable profit for the whole duration of the project without any losses as it reaches a net profit of USD 1 million in 2023, reaching USD 2.1 million in 2047 for a company with a capacity of 32 thousand tons per year. The sequential strategy offers a promising approach for efficient bioethanol production under mild and environmentally friendly conditions that enable its implication industrially.