Volcanic activity has often affected human life both at large and at small scale. For example, the 2010 Eyjafjallajokull eruption caused severe economic damage at continental scale due to its strong effect on air traffic. At a local scale, ash fall and lava flow emission can cause harm and disruption. Understanding precursory signals to volcanic eruptions is still an open and tricky challenge: seismic tremor and gas emissions, for example, are related to upcoming eruptive activity but the mechanisms are not yet completely understood. Furthermore, information related to gases emission mostly comes from the summit crater area of a volcano, which is usually hard to investigate with required accuracy. Although many regulation problems are still on the discussion table, an increasing interest in the application of cutting-edge technology like unmanned flying systems is growing up. In this sense, INGV (Istituto Nazionale di Geofisica e Vulcanologia) started to investigate the possibility to use unmanned air vehicles for volcanic environment application already in 2004. A flight both in visual- and radio-controlled mode was carried out on Stromboli volcano as feasibility test. In this work we present the preliminary results of a test performed by INGV in collaboration with the University of Bologna (aerospace division) by using a multi-rotor aircraft in a hexacopter configuration. Thermal camera observations and flying tests have been realised over a mud volcano located on its SW flank of Mt. Etna and whose activity proved to be related to early stages of magma accumulation within the volcano.
A method is proposed to estimate the swing state of a suspended payload in multirotor drone delivery scenarios. Starting from the equations of motion of the coupled slung load system, defined by two point masses interconnected by a rigid link, a recursive algorithm is developed to estimate cable swing angle and rate from acceleration measurements available from an onboard Inertial Measurement Unit, without the need for extra sensors. The estimation problem is addressed according to the Extended Kalman Filter structure. With respect to the classical linear formulation, the proposed approach allows for improved estimation accuracy in both stationary and maneuvering flight. As an additional contribution, filter performance is enhanced by accounting for aerodynamic disturbance force, which largely affects the estimation accuracy in windy flight conditions. The validity of the proposed methodology is demonstrated as follows. First, it is applied to an octarotor platform where propellers are modeled according to blade element theory and the load is suspended by an elastic cable. Numerical simulations show that estimated swing angle and rate represent suitable feedback variables for payload stabilization, with benefits on flying qualities and energy demand. The algorithm is finally implemented on a small-scale quadrotor and is investigated through an outdoor experimental campaign, thus proving the effectiveness of the approach in a real application scenario.
The cooperative transportation of a cable-suspended load by two unmanned rotorcraft is analyzed. Initially, the equations describing a system composed of three point masses and two rigid cables are derived. The model is then linearized about the hovering condition, and analytical expressions are derived to describe the eigenstructure of the open-loop system. Thanks to the specific parameterization of the problem, the different dynamic modes are outlined and discussed within an analytical framework. A novel controller is designed to enable the UAVs in the formation to perform trajectory tracking, maintain formation geometry, and stabilize payload swing simultaneously. A preliminary investigation of closed-loop stability is conducted using a linear approach. Validation is performed in a realistic simulation scenario where two drones are modeled as rigid bodies under the effect of external disturbances and rotor-generated forces and moments, as obtained by Blade Element Theory. The proposed method demonstrates relative simplicity and significantly improves the flying qualities of delivery operations while minimizing hazardous payload oscillations and reducing energy demand.