The paper addresses the study and design of the autorotation maneuver for a remotely operated helicopter model, developing guidance and control algorithms to automatically track the designed maneuver in case of engine failure. The steady descent phase is investigated first, during which the rotor angular rate and helicopter velocity components are kept at constant values. During the final flare, rotor kinetic energy is exploited to decrease helicopter speed and sink rate before touchdown. If simple polynomial functions are adopted for velocity components during the flare as a function of altitude, the whole maneuver is identified on the basis of a reduced number of parameters, namely, the velocity components during the steady descent and the threshold altitude for starting the flare. An optimization algorithm allows for the selection of the set of maneuver design parameters that result in a minimum residual forward speed at touchdown. Guidance and control logic for the two phases are developed and tested in a number of simulations, proving that the controllers adequately track the designed trajectory, bringing the helicopter to the ground with minimum residual velocity. Robustness with respect to model errors and initial conditions is also demonstrated.
In the present paper, a flight dynamics model is adopted to represent the trim and stability characteristics of a side-by-side helicopter in hovering conditions. This paper develops a numerical representation of the rotorcraft behavior and proposes a set of guidelines for trimming and linearizing the highly coupled rotor dynamics derived by the modeling approach. The trim algorithm presents two nested loops to compute a solution of the steady-state conditions averaged around one blade’s revolution. On the other hand, a 38-state-space linear representation of the helicopter and rotor dynamics is obtained to study the effects of flap, lead–lag, and inflow on the overall stability. The results are compared with an analytical framework developed to validate the rotorcraft stability and compare different modeling approaches. The analysis showed that non-uniform inflow modeling led to a coupled longitudinal inflow–phugoid mode which made the vehicle prone to dangerous instabilities. The flap and lead–lag dynamics introduced damping in the system and can be considered beneficial for rotor dynamics.
This paper aims to explore the development of a flight dynamics model for a small-scale side-by-side helicopter and describe its trim and stability characteristics. The helicopter is considered a suitable candidate for Urban Air Mobility (UAM) solutions, because of its reliable design and low noise characteristics, but still very small knowledge is present on the mathematical modeling approaches and dynamic properties. A 14 degrees of freedom nonlinear mathematical model is developed and semi-analytical models are employed to account for the presence of the shrouds. An iterative trim routine is developed and applied with a suitable control mix that allows the use of classic helicopter controls. To control the vertical speed and roll rate, the paper assumes an equal collective pitch and lateral cyclic in the two rotors, while a uniform plus a differential longitudinal cyclic is adopted for pitch and yaw maneuvers. The paper discusses unique characteristics of the side-by-side configuration as obtained from the stability analysis: an unstable high-frequency mode, governed by the vertical velocity and pitch angle arises when the center of gravity (CG) of the vehicle is aligned or placed in front of the two main rotors. Similarly, both lateral phugoid and roll subsidence modes are sensitive to the CG location. The side-by-side configuration presents also a stable spiral mode which needs to be carefully designed.