In order to reduce the additional resistance of high-speed amphibious vehicles, Flanks are designed on the concave grooves. As a new drag reduction attachment, the principle of Flanks is analyzed and discussed in detail. In this paper, the HSAV model and Flanks coupling resistance tests are performed based on the Reynolds-averaged Navier–Stokes method and SST model. The accuracy of the numerical approach is verified by a series of towing tests. Results show that with a fixed installation angle and invariable characteristic parameters, Flanks can significantly reduce the total resistance at high speed, with a maximum drag reduction of 16%. In the meantime, Flanks also affect the attitude and flow field of the vehicle, consequently affecting the resistance composition and the sailing condition. A vehicle model self-propulsion test is designed and carried out, and it qualitatively verifies the drag reduction effect of the Flanks at high speed.
A numerical approach is established to study the hydrodynamic performance using an amphibious transport vehicle (ATV) as a research object. Numerical calculation based on the Reynolds average Navier–Stokes method is studied in terms of first layer grid height, surface meshing partition scale, and prismatic layer coefficient. Through uncertainty analysis, the correctness and convergence of the numerical approach are verified. Towing tests are conducted to compare the experimental data with the simulation results, which validated the reliability of the numerical approach under all working conditions. Results show that the numerical approach will affect the simulated results, with an average error of 3.91% for the resistance and 4.21% for the trim, meeting the requirements for analysis accuracy. Based on the proposed numerical approach, an optimization design is carried out to improve the hydrodynamic performance of the ATV. Effects of bow plate angle, stern flap angle, and stern flap install height are studied. Latin hypercube is used for sampling in optimization design, and the Kriging method is applied to establish an approximate model. The cross-validation is carried out using the leave-one-out method. Particle swarm optimization is used for parameter optimization, and the optimized configuration is verified using the numerical approach. Results indicate that the combination of bow plate and stern flap shows excellent improvement in the hydrodynamic performance of amphibious vehicles. Numerical error of the approximate model is only 0.292%, which fully verifies its accuracy and effectiveness. The optimized ATV configuration shows the best drag reduction performance of 38.81% compared to the original model.
In this study, the resistance characteristics of the amphibious vehicle in the transitional stage are studied. A deformable track wheel is designed and its effect on the amphibious vehicle’s resistance is studied. The numerical calculation method based on the RANS solver and the towing test method is used to analyse the hydrodynamic performance of the amphibious vehicle. Based on the comparison of the vehicle model with no wheel, the influence of wheels on additional resistance at the groove fault is studied. The inclination angles of the front and rear deformation wheels are studied respectively. The influence and principle of the track wheel configuration on drag are analysed and expounded in terms of pressure distribution, water climbing and spray on the wheel grooves, and the hull attitude. Finally, an adjustment strategy of the deformable configuration wheel in the transition stage is proposed.