The main objective of this research is to investigate the adsorption isotherms and the optimization of the carbon dioxide (CO2) adsorption process on activated carbon (AC). The AC has been characterized by X-ray diffraction, scanning electron microscopy, and nitrogen (N2) adsorption-desorption. The CO2 isotherms measured under three adsorption temperatures (318, 308, and 298 K) were investigated by the Langmuir and linear driving force model. It is found that the Langmuir model could well predict the adsorption behavior of AC with a correlation factor of about 0.99. The kinetic model shows that the amount of CO2 increases at higher pressures. The response surface methodology (RSM) was applied to investigate the effects of process variables and their interaction on the response to reach the optimal conditions. Based on the analysis of variance, pressure and temperature are the main factors influencing the CO2 adsorption capacity. The effective parameters obtained through this model are found to have a value of p < 0.05. In addition, a semiempirical correlation was developed under the optimal operating conditions which are 25 °C and 9 bar. The results indicated that RSM models provide an effective method for evaluating CO2 adsorption. These results point that AC is a potential adsorbent for CO2 capture.
The current study aimed to investigate the CO2 adsorption isotherms of activated carbon (AC), prepared from olive waste via chemical activation by H3PO4. The textural parameters, the microstructural and morphological characterization of the AC were characterized by N2 adsorption-desorption, SEM and XRD. The AC presented the best textural properties with a BET surface area of 1565 m2 g−1 and a micropore volume of 0.649 cm3 g−1. The CO2 adsorption was measured with a volumetric method at three various temperatures: 298 K, 308 K and 318 K. Different models, such as the Langmuir and Freundlich isotherms, were applied to model the CO2 adsorption. Based on the correlation coefficient (R2), the Langmuir model provided a the best fit with the experimental data. Different thermodynamic functions, such as Gibbs free energy and entropy, were calculated using Van Hoff’s formulation. These thermodynamic parameters indicated that the CO2 adsorption is an exothermic and spontaneous process. The results obtained in this study can serve as a benchmark while designing an adsorption-based gas storage system. the Freundlich
Adsorption equilibrium and kinetics of CO2, H2 and CH4 on zeolite 13 X were carried out using the volumetric method. The zeolite 13 X was characterized via XRD, SEM and N2 adsorption-desorption. Adsorption isotherms of various gas were investigated over a full range of temperatures at 298, 308 and 313 K. Langmuir's equilibrium model and the heat of adsorption was used to correlate the adsorption isotherms over a wide range of pressure. A classical micropore diffusion approach was applied to investigate the kinetic adsorption. At 298 K, the selectivity of CO2/H2 and CO2/CH4 of the zeolite 13 X was 16.52 and 62.61, respectively. However, zeolite 13 X is one of the most suitable adsorbents for CO2 and CH4 storage, since it has a very high adsorption capacity for both gases. The influence of gas pressure on diffusivity for various absorber-adsorbent systems has been examined. The adsorption experiments with gas mixtures such as H2, CO2 and CH4 on 13 X zeolite show that this adsorbent has potential application in the gas separation and purification process.
The present study as designed to assess the CO2 and N2 adsorption isotherms on activated carbon (AC). The AC was characterized with SEM, XRD and N2 isotherm. The CO2 and the N2 adsorption experiments on the AC are performed at 298, 308 and 328 K and modelled by Langmuir model. The preferred selectivity (αCO2/N2) was obtained with the use of the Langmuir properties and the Henry coefficient (KH) was found from the virial equation. The thermodynamic analysis of CO2 and N2 adsorption which include the entropy loss (ΔS), the Gibbs free energy change (ΔG) and the surface potential (Ω) was calculated. The results reveal that the order of CO2 uptake on AC is higher than that of N2. α(CO2/N2) decreased with the increase of the temperature. The KH values of CO2 on the AC are the most important, while the KH values for N2 are the least. The thermodynamic parameters which include Ω, ΔG and ΔS are impacted by the porous structure of the AC.The adsorption affinity and the adsorption spontaneity of CO2 is the highest, while N2 has the lowest adsorption spontaneity. Subsequently, CO2 exhibits a higher interaction with AC, in contrast to N2 which displays a slight interaction.the obtained results can be used to CO2 capture and to improve the efficiency of CO2 adsorption devices.