High-manganese steel (HMnS) coating was prepared using laser wire feeding cladding technology. Erosion damage behavior and erosion rate of both the HMnS coating and the HMnS substrate were investigated at room temperature using an erosion testing machine. SEM/EDS, XRD, EPMA, and microhardness analyses were used to characterize the cross sections of the coating and matrix, as well as the morphology, phase composition, and microhardness of the eroded surface. The phase composition, orientation characteristics, and grain size of the eroded surfaces of both the coating and substrate were examined by using the EBSD technique. The erosion mechanism under different erosion angles was revealed. By analyzing the plastic deformation behavior of the subsurface of the HMnS coating, the impact hardening mechanism of the high-manganese steel coating during the erosion process was investigated. The results demonstrated that the HMnS coating, prepared through laser wire feeding cladding, exhibited excellent metallurgical bonding with the substrate, featuring a dense microstructure without any cracks. The erosion rate of the coatings was lower than that of the substrate at different erosion angles, with the maximum erosion rate occurring at 35° and 50°. The damage to the coating and substrate under low-angle erosion was primarily attributed to the micro-cutting of erosion particles and a minor amount of hammering. At the 90° angle, the dominant factor was hammering. After erosion, the microhardness of both the coating and substrate sublayer increased to 380HV0.3 and 359HV0.3, respectively. Dendrite segregation, refined grains, low-angle grain boundaries, and localized dislocations, generated by laser wire feeding cladding, contributed to the deformation process of HMnS. These factors collectively enhance the hardening behavior of HMnS coatings, thereby providing excellent erosion resistance.

With the aim of understanding cavitation damage of stainless steel under the effect of cavitation collapse in an aqueous environment, morphology, phase, chemical state, electrochemical, and other properties after cavitation and erosion are methodically examined. The obtained results indicate that the addition of metal ions in pure water strengthens the dynamic effect of cavitation collapse. When the cavitation collapses, it is capable of releasing a high temperature and transferring it to the surface of the stainless steel in a short time. Then, through the rapid cooling of the pure water environment, the martensitic structure is generated, but the presence of a massive amount of metal ions leads to a decrease in the speed of heat conduction and absorption of some heat. After the collapse of the bubble, the passivation film on the surface of the stainless steel incorporates into the creation of initial micropores. A concentration difference and a growth of the current density at the bottom of the hole, as well as a reduction in the pH value are detectable. Compared with pure water, 3.5% NaCl solution contains more free ions and its local current density is higher, so its corrosion resistance is worse.