Beata Biernacka

Dr. Beata Biernacka

Department of Thermal Technology and Food Process Engineering, University of Life Sciences in Lublin, 31 Głęboka St., 20-612 Lublin, Poland
orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2017 in LWT
Verified
Journal Article
Closed access
Beata BiernackaBeata Biernacka
Beata Biernacka
DDDariusz Dziki
Dariusz Dziki
Urszula Gawlik-DzikiUrszula Gawlik-Dziki
Urszula Gawlik-Dziki
RRRenata Rozylo
Renata Rozylo
MSMonika Siastała
Monika Siastała


16 May 2019 in International Agrophysics
Verified
Journal Article
Open access
RRRenata Rozylo
Renata Rozylo
Monika WójcikMonika Wójcik
Monika Wójcik
DDDariusz Dziki
Dariusz Dziki
Beata BiernackaBeata Biernacka
Beata Biernacka
GCGrażyna Cacak-Pietrzak
Grażyna Cacak-Pietrzak
AZAdam Zdybel
Adam Zdybel

25 December 2020 in Processes
Verified
Journal Article
Open access
PDF file
WHWaleed Hassoon
Waleed Hassoon
DDDariusz Dziki
Dariusz Dziki
AMAntoni Miś
Antoni Miś
Beata BiernackaBeata Biernacka
Beata Biernacka
The objective of this study was to determine the grinding characteristics of wheat with a low moisture content. Two kinds of wheat—soft spelt wheat and hard Khorasan wheat—were dried at 45 °C to reduce the moisture content from 12% to 5% (wet basis). Air drying at 45 °C and storage in a climatic chamber (45 °C, 10% relative humidity) were the methods used for grain dehydration. The grinding process was carried out using a knife mill. After grinding, the particle size distribution, average particle size and grinding energy indices were determined. In addition, the dough mixing properties of wholemeal flour dough were studied using a farinograph. It was observed that decreasing the moisture content in wheat grains from 12% to 5% made the grinding process more effective. As a result, the average particle size of the ground material was decreased. This effect was found in both soft and hard wheat. Importantly, lowering the grain moisture led to about a twofold decrease in the required grinding energy. Moreover, the flour obtained from the dried grains showed higher water absorption and higher dough stability during mixing. However, the method of grain dehydration had little or no effect on the results of the grinding process or dough properties.

5 January 2020 in Foods
Verified
Journal Article
Open access
PDF file
Beata BiernackaBeata Biernacka
Beata Biernacka
DDDariusz Dziki
Dariusz Dziki
RRRenata Rozylo
Renata Rozylo
Urszula Gawlik-DzikiUrszula Gawlik-Dziki
Urszula Gawlik-Dziki
This study aimed to analyse the effect of dried banana powder (BP) on common wheat pasta characteristics. Wheat flour (type 500) was replaced with 1%, 2%, 3%, 4% and 5% of BP. Control pasta without BP addition was also prepared. Pasta quality parameters including texture, colour, cooking characteristics and sensory evaluation were determined. Total phenolics content and antioxidant activity were also evaluated. The increase in BP in the pasta recipe resulted in an increase in the weight increase index (from 2.88 to 3.55) and cooking loss (from 5.2% to 6.4%). The effects of the addition of bananas were also observed in changes in colour coordinates. It was shown that BP slightly decreased the lightness of cooked pasta and had little influence on colour coordinates of raw pasta. It was also found that the addition of BP higher than 3% decreased pasta firmness. The total phenolics content and antioxidant capacity of pasta increased with the addition of BP. Sensory evaluation of pasta showed that the replacement of common wheat flour with BP should not exceed 3%.

31 October 2024 in Molecules
Verified
Journal Article
Open access
PDF file
AKAndrzej Krzykowski
Andrzej Krzykowski
SRStanisław Rudy
Stanisław Rudy
Renata PolakRenata Polak
Renata Polak
Beata BiernackaBeata Biernacka
Beata Biernacka
AKAnna Krajewska
Anna Krajewska
DDDariusz Dziki
Dariusz Dziki
Studies were conducted focusing on the drying of chili pepper fruits (Capsicum annuum L.), cultivar Cyklon, using convective (AD), convective-microwave (AMD), vacuum (VD), and freeze-drying (FD) methods. The influence of the drying method and temperature on the kinetics of the process and selected quality attributes of the dried product were evaluated. It was demonstrated that the Midilli model best described the drying kinetics for all methods across the entire measurement range. FD and VD produced dried products with the highest brightness and the greatest value of the a* color parameter. The lowest b* color parameter was observed for the product dried using FD at 40 °C, while the highest b* value was noted for samples dried using AMD (100 W) at 60 °C. The highest carotenoid retention was achieved with the FD method at 40 °C, while the lowest carotenoid content was found in the product obtained using the AMD method (100 W) at 60 °C. The smallest losses of capsaicinoids were observed after FD drying at 40 °C, while the largest were found for AMD (100 W) at 60 °C. The analysis of chili pepper fruit extracts revealed the quantitative composition of 12 main phenolic compounds using the UHPLC-UV method. The highest polyphenol content was obtained with FD, while the lowest total polyphenol content was recorded after AD. Regardless of temperature, the total flavonoid content was highest in extracts from FD products, and the lowest flavonoid content was found after AMD at 100 W. For all drying methods analyzed, the total flavonoid content in the pepper extracts decreased with increasing temperature.