Radiation holds great potential to energize the synthesis and modification of nanomaterials with high efficiency, simplicity, scalability, and environmental friendliness.
10 February 2021 in The Journal of Physical Chemistry C
Two-dimensional (2D) MoS2 is a promising material for future electronic and optoelectronic applications. 2D MoS2 devices have been shown to perform reliably under irradiation conditions relevant for a low Earth orbit. However, a systematic investigation of the stability of 2D MoS2 crystals under high-dose gamma irradiation is still missing. In this work, absorbed doses of up to 1000 kGy are administered to 2D MoS2. Radiation damage is monitored via optical microscopy and Raman, photoluminescence, and X-ray photoelectron spectroscopy techniques. After irradiation with 500 kGy dose, p-doping of the monolayer MoS2 is observed and attributed to the adsorption of O2 onto created vacancies. Extensive oxidation of the MoS2 crystal is attributed to reactions involving the products of adsorbate radiolysis. Edge-selective radiolytic etching of the uppermost layer in 2D MoS2 is attributed to the high reactivity of active edge sites. After irradiation with 1000 kGy, the monolayer MoS2 crystals appear to be completely etched. This holistic study reveals the previously unreported effects of high-dose gamma irradiation on the physical and chemical properties of 2D MoS2. Consequently, it demonstrates that radiation shielding, adsorbate concentrations, and required device lifetimes must be carefully considered, if devices incorporating 2D MoS2 are intended for use in high-dose radiation environments.
Highly crystalline anatase TiO 2 nanosheets, made by controlled oxidation of TiS 2 nanosheets, expose the {001} and {100} facets, giving rise to enhancement in HER as compared to Degussa P25 TiO 2 nanoparticles. No enhancement in ORR was observed.
10 April 2019 in Molecular Systems Design & Engineering
Liquid-phase exfoliation (LPE) of graphite shows great potential as a mass scalable and low-cost method for production of solution-processed graphene, which can be used for a wide range of applications. Due to the hydrophobic nature of graphene, a stabilising agent is needed to exfoliate graphite in water – in particular, pyrene derivatives have been shown to be very effective in exfoliating graphite, by producing either positively or negatively charged dispersions, depending on the functional group used. In this work we have synthesised amphoteric pyrene derivatives, using amino acid-based functional groups (lysine and taurine), and tested them as exfoliating agents for LPE of graphene. Atomic force microscopy shows the flakes to have an average size between 100 and 300 nm, while qualitative Raman analysis shows the dispersion to be composed mainly of single and few-layer flakes, as also confirmed by transmission electron microscopy. Finally, we demonstrate that the surface charge of graphene can be adjusted by a systematic change of the pH level. Although both stabilisers demonstrated to be able to exfoliate graphite in water, pyrene-based lysine produces more concentrated and stable graphene dispersions, whose surface charge changes between positive and negative depending on the pH level. In contrast, sedimentation of the dispersed material was observed at extreme pH for graphene dispersions obtained with pyrene-substituted taurine. This is attributed to the low pKa value of the sulfonic group in taurine, which remains negatively charged even at very low pH.
25 November 2019 in Journal of Materials Chemistry A
Utilizing reducing species generated by high-energy photons offers an alternative strategy to prepare metal nanoparticles (NPs) in the absence of a foreign reductant. However, fine control of the NP size and dispersity remains a big challenge. Herein, we report that by properly selecting the solvent, precursor concentration and carbon support, ultrafine palladium (Pd) NPs with an average size of 3.0 nm uniformly distributed on nitrogen-doped graphene (NG) are radiolytically prepared. Control experiments demonstrate that ethylene glycol with moderate reducibility is a superior solvent to water. Among four graphene-based supports with distinct functionalization or doping, nitrogen dopants outperform oxygen functional groups in anchoring the NPs and controlling their size and dispersity. Pd/NG also affords the lowest η10 (overpotential at a current density of 10 mA cm−2) toward the hydrogen evolution reaction (HER). Comparison of Pd/NG with varied Pd loadings indicates that the HER activity nearly reaches a plateau once the loading increases to 2.6 wt%, which is limited by the nitrogen content of NG. X-ray photoelectron spectroscopy unambiguously reveals the electron transfer from electron-rich Pd to electron-deficient nitrogen, especially graphitic nitrogen, corroborating the decisive role of doped nitrogen in stabilizing the Pd NPs on NG. Extending this synthesis to platinum (Pt) yields Pt/NG that presents even lower η10 than the commercial 10 wt% Pt/carbon black due to the smaller NP size. These results collectively highlight the potential of high-energy photons for green, versatile and scalable synthesis of heterogeneous nanostructures.
Ion irradiation is a versatile tool to introduce controlled defects into two-dimensional (2D) MoS2 on account of its unique spatial resolution and plethora of ion types and energies available. In order to fully realise the potential of this technique, a holistic understanding of ion-induced defect production in 2D MoS2 crystals of different thicknesses is mandatory. X-ray photoelectron spectroscopy, electron diffraction and Raman spectroscopy show that thinner MoS2 crystals are more susceptible to radiation damage caused by 225 keV Xe+ ions. However, the rate of defect production in quadrilayer and bulk crystals is not significantly different under our experimental conditions. The rate at which S atoms are sputtered as a function of radiation exposure is considerably higher for monolayer MoS2, compared to bulk crystals, leading to MoO3 formation. P-doping of MoS2 is observed and attributed to the acceptor states introduced by vacancies and charge transfer interactions with adsorbed species. Moreover, the out-of-plane vibrational properties of irradiated MoS2 crystals are shown to be strongly thickness-dependent: in mono- and bilayer MoS2, the confinement of phonons by defects results in a blueshift of the mode. Whereas, a redshift is observed in bulk crystals due to attenuation of the effective restoring forces acting on S atoms caused by vacancies in adjacent MoS2 layers. Consequently, the frequency of tri- and quadrilayer crystals is statistically invariant on account oft competition between phonon confinement effects and interlayer interactions. The linewidth is observed to decrease in bi- and trilayer crystals after low dose irradiation and is attributed to layer decoupling. This work shows that there is a complex interplay between defect production, crystal thickness and interlayer interactions in MoS2. Our results demonstrate that ion irradiation is an effective tool to modulate the electronic, vibrational and structural properties of MoS2, which may prove beneficial for practical applications.