We report a detailed analysis about the memory soft error rate (SER) dependence with transistor design parameters for six-transistor (6T) SRAM cells fabricated on a 65-nm CMOS commercial technology. SER data are obtained from accelerated test with an Am-241 alpha source. Five 6T cells with different nMOS and pMOS transistors size combinations were fabricated and characterized. After verifying that transistor width increase always provides higher critical charge values, SER data show that this value is improved only when increasing the pMOS transistors width. Memory cells containing non-minimum-width nMOS transistors always exhibit worse SER values than cells with minimum-size ones. In addition, one cell with a higher Q crit than another can show a worse SER depending on the transistor type whose size is being enlarged. Accordingly to this, we have found that SER may be increased by 76% without modifying cell structure nor impacting cell area. This behavior is qualitatively and quantitatively explained through an analytical model that relates SER to Q crit and the transistor design parameters.
Physically unclonable functions (PUFs) are used as low-cost cryptographic primitives in device authentication and secret key creation. SRAM-PUFs are well-known as entropy sources; nevertheless, due of non-deterministic noise environment during the power-up process, they are subject to low challenge-response repeatability. The dependability of SRAM-PUFs is usually accomplished by combining complex error correcting codes (ECCs) with fuzzy extractor structures resulting in an increase in power consumption, area, cost, and design complexity. In this study, we established effective metrics on the basis of the separatrix concept and cell mismatch to estimate the percentage of cells that, due to the effect of variability, will tend to the same initial state during power-up. The effects of noise and temperature in cell start-up processes were used to validate the proposed metrics. The presented metrics may be applied at the SRAM-PUF design phases to investigate the impact of different design parameters on the percentage of reliable cells for PUF applications.
This work proposes a methodology to estimate the statistical distribution of the probability that a 6T bit-cell starts up to a given logic value in SRAM memories for PUF applications. First, the distribution is obtained experimentally in a 65-nm CMOS device. As this distribution cannot be reproduced by electrical simulation, we explore the use of an alternative parameter defined as the distance between the origin and the separatrix in the bit-cell state space to quantify the mismatch of the cell. The resulting distribution of this parameter obtained from Monte Carlo simulations is then related to the start-up probability distribution using a two-component logistic function. The reported results show that the proposed imbalance factor is a good predictor for PUF-related reliability estimation with the advantage that can be applied at the early design stages.
26 March 2020 in IEEE Transactions on Nuclear Science
We present experimental results about the impact of transistor width modulation and power supply voltage variation on the alpha-SER in a 65 nm CMOS 6T SRAM obtained from an accelerated test experiment using an Am-241 alpha source. Five 6T cells with various combinations of transistor widths were tested, results show that nMOS and pMOS widths play a different role on SER. We also found that transistor width modulation effectiveness is highly dependent on the power supply voltage. In particular, results show that at around nominal voltages, widening all pMOS, while keeping all nMOS minimum sized, is the best way to improve SER. However, at lower voltages results become completely different and the best option for an overall SER improvement is to keep all transistors minimum sized.