A thermoelectric module is a device that converts electrical energy into thermal energy through a mechanism known as the Peltier effect. A Peltier device has hot and cold sides/substrates, and heat can be pumped from the cold side to the hot side under a given voltage. By applying it in buildings and attaching it to building envelope components, such as walls, as a heating and cooling device, the heating and cooling requirements can be met by reversing the voltage applied on these two sides/substrates. In this paper, we describe a novel, panelized, ground source, radiant system design for space heating and cooling in buildings by utilizing the Peltier effect. The system is equipped with water pipes that are attached to one side of the panel and connected with a ground loop to exchange heat between the cold/hot sides of the thermoelectric module and the underground region. The ground loop is inserted in boreholes, similar to those used for a vertical closed-loop Ground Source Heat Pump (GSHP) system, which could be more than a hundred meters deep. Experiments were conducted to evaluate the feasibility of the developed panel system applied in buildings. The results show that: (1) the average cooling Coefficients Of Performance (COP) of the system are low (0.6 or less) even though the ground is used as a heat sink, and thus additional studies are needed to improve it in the future, such as to arrange the thermoelectric modules in cascade and/or develop a new thermoelectric material that has a large Seebeck coefficient; and (2) the developed system using the underground region as the heat source has the potential of meeting heating loads of a building while maintaining at a higher system coefficient of performance (up to ~3.0) for space heating, compared to conventional heating devices, such as furnaces or boilers, especially in a region with mild winters and relatively warm ground.
Structural snow fences are known as a cost-effective way to enhance road safety on highways, which, however, are only used during winter, making them “useless” during summer. To increase their cost-effectiveness, Photovoltaics Snow Fences (PVSF) were developed by integrating PV panels with conventional structural snow fences. As part of the feasibility study supported by the Minnesota Department of Transportation (MnDOT), a financial analysis was performed involving many parameters, such as the capital and operating costs of the PVSF system, installation orientation of the panels, discount rates, energy selling prices, availability of incentives, ownership of the PV system, etc. The effects of these parameters on the analysis results were evaluated, where critical (most sensitive) parameters were first identified, and then their quantitative effects on the analysis results were evaluated in terms of Net Present Value (NPV) and Internal Rate of Return (IRR). The results indicate that the real discount rate is the most sensitive parameter in determining the cost-effectiveness of a PVSF project in Minnesota by looking at its NPV, when the benefits, such as Federal Tax Credits, Renewable Energy Certificates, and those associated with the use of snow fences, are considered in the financial analysis. The cost of the PVSF system is the most sensitive parameter for IRR, depending on the ownership of the PV system (by MnDOT or via a Power Purchase Agreement).