The advent of large digital datasets from unmanned aerial vehicle (UAV) and satellite platforms now challenges our ability to extract information across multiple scales in a timely manner, often meaning that the full value of the data is not realised. Here we adapt a least-cost-path solver and specially tailored cost functions to rapidly interpolate structural features between manually defined control points in point cloud and raster datasets. We implement the method in the geographic information system QGIS and the point cloud and mesh processing software CloudCompare. Using these implementations, the method can be applied to a variety of three-dimensional (3-D) and two-dimensional (2-D) datasets, including high-resolution aerial imagery, digital outcrop models, digital elevation models (DEMs) and geophysical grids. We demonstrate the algorithm with four diverse applications in which we extract (1) joint and contact patterns in high-resolution orthophotographs, (2) fracture patterns in a dense 3-D point cloud, (3) earthquake surface ruptures of the Greendale Fault associated with the Mw7.1 Darfield earthquake (New Zealand) from high-resolution light detection and ranging (lidar) data, and (4) oceanic fracture zones from bathymetric data of the North Atlantic. The approach improves the consistency of the interpretation process while retaining expert guidance and achieves significant improvements (35–65 %) in digitisation time compared to traditional methods. Furthermore, it opens up new possibilities for data synthesis and can quantify the agreement between datasets and an interpretation.
The new generation of satellite hyperspectral (HS) sensors provides remarkable potential for regional-scale mineralogical mapping. However, as with any satellite sensor, mapping results are dependent on a typically complex correction procedure needed to remove atmospheric, topographic and geometric distortions before accurate reflectance spectra can be retrieved. These are typically applied by the satellite operators but use different approaches that can yield different results. In this study, we conduct a comparative analysis of PRISMA, EnMAP, and EMIT hyperspectral satellite data, alongside airborne data acquired by the HyMap sensor, to investigate the consistency between these datasets and their suitability for geological mapping. Two sites in Namibia were selected for this comparison, the Marinkas-Quellen and Epembe carbonatite complexes, based on their geological significance, relatively good exposure, arid climate and data availability. We conducted qualitative and three different quantitative comparisons of the hyperspectral data from these sites. These included correlative comparisons of (1) the reflectance values across the visible-near infrared (VNIR) to shortwave infrared (SWIR) spectral ranges, (2) established spectral indices sensitive to minerals we expect in each of the scenes, and (3) spectral abundances estimated using linear unmixing. The results highlighted a notable shift in inter-sensor consistency between the VNIR and SWIR spectral ranges, with the VNIR range being more similar between the compared sensors than the SWIR. Our qualitative comparisons suggest that the SWIR spectra from the EnMAP and EMIT sensors are the most interpretable (show the most distinct absorption features) but that latent features (i.e., endmember abundances) from the HyMap and PRISMA sensors are consistent with geological variations. We conclude that our results reinforce the need for accurate radiometric and topographic corrections, especially for the SWIR range most commonly used for geological mapping.