The closed architecture and stand-alone operation model of traditional industrial control systems limit their ability to leverage ubiquitous infrastructure resources for more flexible and intelligent development. This restriction hinders their ability to rapidly, economically, and sustainably respond to mass customization demands. Existing proposals for open and networked architectures have failed to break the vicious cycle of closed architectures and stand-alone operation models because they do not address the core issue: the tight coupling among the control, infrastructure, and actuator domains. This paper proposes a reconfigurable architecture that decouples these domains, structuring the control system across three planes: control, infrastructure, and actuator. The computer numerical control (CNC) system serves as a primary example to illustrate this reconfigurable architecture. After reviewing open and networked architectures and discussing the characteristics of this reconfigurable architecture, this paper identifies three key challenges: deterministic control functionality, the decoupling of control modules from infrastructures, and the management of control modules, infrastructures, and actuators. Each challenge is examined in detail, and potential solutions are proposed based on emerging technologies.
The cavity receiver’s thermal conversion performance is critical for parabolic dish and tower Concentrated Solar Power (CSP) systems. Distinct from precedent research aiming to increase the receiver’s absorption through cavity geometry optimization, the objective of this work was to investigate the thermal conversion performance of a novel, positive conical cavity receiver design, following the heat loss reduction approach with simplified pipe forming, to stress the effectiveness of this approach in cavity receiver design, and to provide data for future optimization of the proposed design. To accomplish these goals, the novel receiver and existing designs’ heat flux absorption and heat loss are compared numerically. The resulting conversion power is also experimentally validated. The concept is inspired by analysis of formulas, suggesting the novel design may realize a thermal conversion improvement of 8.6%, at 650 K, and increases with the rise in temperature. The comprehensive numerical investigation combines ray tracing of identical incoming radiation to investigate the receiver absorption and CFD methods to investigate the cavities’ heat loss at identical temperatures. The absorption acquired is unoptimized. The novel design can reduce the heat loss by as much as 91.8% when compared with a negative conical design at 650 K, resulting in a 12.3% improvement in conversion power. The experimental investigation measures the energy conversion to the working fluid in different cavities under identical incoming radiation. The novel receiver outperforms by over 5.6% in the setup. After correcting boundary conditions using experiment measurements, the experimental and numerical results are comparable. This research proves that the novel positive conical receiver has a better thermal conversion performance over 650 K; thus, the heat loss reduction approach is effective and feasible in receiver designs within this temperature range.
Floating foundations play a vital role in exploring offshore energy. After analyzing various floating foundation concepts, this paper presents a novel buoyancy-distributed floating foundation (BDFF) inspired by the decentralized concept. The calculations of a floating system based on the BDFF design were performed for a series of wave conditions. The potential theory and the boundary element method (BEM) were used in the numerical progress. A broader view was focused on the impacts of wave frequency and wave directions on the system. The proposed floating system was further validated through wave tests in a wave tank, showing that the potential theory can satisfactorily predict the RAOs in regular waves. Moreover, numerical results and experimental results were compared with a conventional SPAR. Finally, the coupling relationship between six degrees of freedom was described.