The effect of mold withdrawal velocity, heater and pouring temperatures and the thickness of blade root on the solidification parameters and shape of the liquidus isotherm as well as microstructure of single-crystal CMSX-4 nickel-based superalloy, manufactured by the Bridgman method, has been analyzed in the article. The temperature gradient G, solidification rate v and location of the liquidus isotherm were determined in relation to the radiation baffle on the basis of temperature measurements conducted in nine test points along the height of castings (140 mm) with different thicknesses of root (27, 15 and 7 mm) and withdrawal velocities of 3 and 5 mm/min. The increase of root thickness, relative to the airfoil, resulted in the rise of inhomogeneity of solidification parameters as well as the primary dendrite arm spacing and unsteady state solidification along the whole blade height. However, in the case of blade with constant thickness, the steady-state solidification was created at the distance of 65 to 130 mm from its base. The increase of mold withdrawal velocity caused the decrease of temperature gradient. However, the solidification rate was different from the mold withdrawal velocity, especially in the root and middle part of the airfoil. The increase of heater temperature resulted in a rise of temperature gradient and reduction of the curvature of the liquidus isotherm, whereas the pouring temperature did not affect the solidification parameters in the blade. Particularly unfavorable conditions of the solidification process could occur in the middle part of the airfoil and root because of the lowest value of G/v and the largest primary dendrite arm spacing.

The paper presents the analysis of numerical simulation of the Bridgman directional solidification process performed on CMSX-4 rods. The numerical simulation was studied applying the ProCAST software. The constitutive law parameters of the normal Gaussian distribution were used to describe the nucleation process. The coefficients of the equation were determined and used to calculate the growth rate of dendrite tip. The analysis of the as-cast microstructure was carried out with the use of Aphelion software in order to determine the average area of grains and their quantity. The experimental verification of both nucleation and grain growth coefficients used for the simulation of the directional solidification process confirmed that the model was correct and described well the investigated process of directional solidification using the Bridgman method.