Surface enhanced Raman spectroscopy (SERS) is considered a versatile and multifunctional technique with the ability to detect molecules of different species at very low molar concentration. In this work, hierarchical ZnO microspheres (ZnO MSs) and Ag/ZnO MSs were fabricated and decorated by hydrothermal and photodeposition methods, respectively. For Ag deposition, precursor molar concentration (1.9 and 9.8 mM) and UV irradiation time (5, 15, and 30 min) were evaluated by SEM, TEM, X-ray diffraction and Raman spectroscopy. X-ray diffraction showed a peak at 37.9° corresponding to the (111) plane of Ag, whose intensity increases as precursor concentration and UV irradiation time increases. SEM images confirmed the formation of ZnO MSs (from 2.5 to 4.5 µm) building by radially aligned two-dimensional ZnO nanosheets with thicknesses below 30 nm. The Raman spectra of Ag/ZnO MSs exhibited a vibration mode at 486 cm−1 which can be directly associated to Ag deposition on ZnO MSs surface. The performance of SERS substrate was evaluated using rhodamine 6G. The SERS substrate grown at 9.8 mM during 30 min showed the best SERS activity and the ability to detect methylene blue at 10−9 M.
27 October 2023 in Journal of Chemical Technology & Biotechnology
This work demonstrates an optimized sample-loading method that enables SERS crystal violet detection down to 10 −13 M with a total detection time of only 3 min, offering a rapid and practical analytical approach.
16 September 2025 in Journal of Solid State Chemistry
A homogeneous photocatalyst on a stable substrate is required for photocatalytic reactors in wastewater treatment. ZnO films were synthesized on stainless steel prepared by the spray pyrolysis technique at different deposition temperatures (350 to 500 °C in steps of 50 °C). Scanning electron microscopy showed microflowers formed by nanopetals with an average size of 2 μm. The ZnO wurtzite structure and its defects were studied by Raman spectroscopy, X-ray diffraction, diffuse reflectance, and photoluminescence spectroscopy. A deposition temperature of 400 °C was chosen due to the presence of a higher number of vibrational modes, better distribution of microflowers, smaller crystallite size and a higher number of defects than the other options. Lanthanides were incorporated into ZnO by solution spraying, and then thermal treatment was performed at 600 °C. The photocatalytic evaluation of ZnO showed the best photocatalytic activity under UV light at 365 nm with a 69.34% degradation efficiency at 120 min. Photocatalytic activity toward methylene blue degradation was enhanced in ZnO:Ce3+ (2 and 4 atom%) and ZnO:Nd3+ (0.05 and 2 atom%) samples, achieving degradation efficiencies above 90% within 30 min of UV–visible light irradiation.