An exceedingly small number of high‐pressure polymorphs have been discovered in lunar samples. This situation does not seem to reconcile with the prolonged, intense bombardment of the lunar surface, which should produce suitable conditions for the formation of such polymorphs. Here we report the discovery of reidite, a high‐pressure polymorph of ZrSiO4 with scheelite structure in lunar meteorite Sayh al Uhaymir (SaU) 169. The reidite occurs mainly as lamellae hosted within zircon, likely corresponding to a deviatoric‐dominated transformation. The presence of reidite in the regolith portion of SaU 169 indicates a narrow temperature and pressure path constrained by the phase stability under low pressure and suggests heterogeneous shock features in the porous lunar regolith where the ambient temperature increases much higher than that in compact rocks. The inventory of high‐pressure polymorphs might be restricted by such unusual cooling processes lunar samples experienced.
Forsterite (Mg2SiO4) is one of the major planetary materials, and its behavior under extreme conditions is important to understand the interior structure of large planets, such as super-Earths, and large-scale planetary impact events. Previous shock compression measurements of forsterite indicate that it may melt below 200 GPa, but these measurements did not go beyond 200 GPa. We report the shock response of forsterite above ~250 GPa, obtained using the laser shock wave technique. We simultaneously measured the Hugoniot and temperature of shocked forsterite and interpreted the results to suggest the following: (i) incongruent crystallization of MgO at 271 to 285 GPa, (ii) phase transition of MgO at 285 to 344 GPa, and (iii) remelting above ~470 to 500 GPa. These exothermic and endothermic reactions are seen to occur under extreme conditions of pressure and temperature. They indicate complex structural and chemical changes in the system MgO-SiO2 at extreme pressures and temperatures and will affect the way we understand the interior processes of large rocky planets as well as material transformation by impacts in the formation of planetary systems.
Earth’s outer core is liquid and dominantly composed of iron and nickel (~5–10 wt%). Its density, however, is ~8% lower than that of liquid iron, and requires the presence of a significant amount of light element(s). A good way to specify the light element(s) is a direct comparison of density and sound velocity measurements between seismological data and those of possible candidate compositions at the core conditions. We report the sound velocity measurements of a model core composition in the Fe-Ni-Si system at the outer core conditions by shock-wave experiments. Combining with the previous studies, we found that the best estimate for the outer core’s light elements is ~6 wt% Si, ~2 wt% S, and possible ~1–2.5 wt% O. This composition satisfies the requirements imposed by seismology, geochemistry, and some models of the early core formation. This finding may help us to further constrain the thermal structure of the Earth and the models of Earth’s core formation.
The shock Hugoniot of an Fe‐9 wt %Ni‐10 wt %Si system as a model of the Earth's core has been measured up to ~280 GPa using a two‐stage light‐gas gun. The samples had an average density of 6.853 (±0.036) g/cm3. The relationship between shock velocity (Us) and particle velocity (up) can be described by Us (km/s) = 3.95 (±0.15) + 1.53 (±0.05) up (km/s). The calculated Hugoniot temperatures and the melting curve indicate that the model composition melts above a shock pressure of ~168 GPa, which is significantly lower than the shock‐melting pressure of iron (~225 GPa). A comparison of the pressure‐density (P‐ρ) profiles between the model composition and the preliminary reference Earth model gives a silicon content close to 10 wt %, necessary to compensate the density deficit in the Earth's outer core from seismological observations, if silicon is present as a major light element in the Fe‐Ni core system.
Detailed wave profiles for Kinosaki basalt at pressures up to 25 GPa are measured using a laser velocity interferometer in order to determine the dynamic properties. The results indicate a Hugoniot elastic limit of ∼2 GPa and a relationship between shock velocity (Us) and particle velocity (Up) approximated by Us (km/s) = 3.5 + 1.3Up (km/s) in the low-pressure plastic region (Up below ∼4 km/s). These data are compared with the known data for rocks with basaltic compositions, and tensile strength of the basaltic rocks was found to be about one tenth of that of compression strength.