Lithium–sulfur (Li–S) batteries are the most promising next-generation energy storage devices owing to their excellent theoretical specific capacity (1675 mA h g−1) and the abundant availability of sulfur resources at low costs. However, serious shuttle effects and sluggish reaction kinetics obstruct the practical implementation of Li–S batteries. Herein, a functional separator modified with polytetraphenylporphyrin cobalt adsorbed onto multi-walled carbon nanotubes (PTPPCo/MWCNT) was fabricated by a simple vacuum filtration method. Because of the excellent conductivity of the MWCNT as well as the enhanced chemical adsorption and powerful catalytic activity of PTPPCo, the shuttle effect was effectively suppressed and the reaction kinetics were greatly enhanced. Consequently, the Li–S cells with the modified functional separator PTPPCo/MWCNT showed a prominent initial reversible capacity of 1330 mA h g−1 at a current density of 0.2C, enhanced rate performance, outstanding cycling stability (with a slight average capacity decay of 0.038% per cycle at 2C for 500 cycles), and excellent anti-self-discharge ability.
Chromium Nitride (CrN) coatings have widespread utilization across numerous industrial applications, primarily attributed to their excellent properties. Among the different methods for CrN coating synthesis, direct current magnetron sputtering (DCMS) has been the dominant technique applied. Nonetheless, with the expanded applications of CrN coatings, the need for enhanced mechanical performance is concurrently escalating. High-power impulse magnetron sputtering (HiPIMS), an innovative coating deposition approach developed over the past three decades, is gaining recognition for its capability of yielding coatings with superior mechanical attributes, thereby drawing significant research interest. Considering that the mechanical performance of a coating is fundamentally governed by its microstructural properties, a comprehensive review of CrN coatings fabricated through both techniques is presented. This review of recent literature aims to embark on an insightful comparison between DCMS and HiPIMS, followed by an examination of the microstructure of CrN coatings fabricated via both techniques. Furthermore, the exploration of the underlying factors contributing to the disparities in mechanical properties observed in CrN coatings is revealed. An assessment of the advantages and potential shortcomings of HiPIMS is discussed, offering insight into CrN coating fabrication.
Magnetism in graphene has stimulated extensive studies to search for novel metal-free magnetic device. In this paper, we use a synthesis method far from equilibrium state named self-propagating high temperature synthesis (SHS) to produce few-layer graphene with different defect contents and then use a heat treatment process (vacuum-annealing and air-cooling) to further control the defects in graphene. We find that the type and content of defects in graphene can be controlled by adjusting the mole ratio of reactants (Mg: CaCO3) for SHS reaction and the temperature of the subsequent heat treatment. The deviation of the ratio of reactants from stoichiometric ratio benefits the production of graphene with higher concentration of defects. It is indicated that the temperature of the heat treatment has remarkable influences on the structure of graphene, Raman-sensitive defects can be recovered partly by heat treatment while IR-sensitive defects are closely related with the oxidation and decomposition of the oxygen-containing groups at elevated temperature. This work indicates that SHS is a promising method to produce graphene with special magnetism, and the heat treatment is an effective way to further adjust the magnetism of graphene. This work sheds light on the study to develop carbon materials with controlled ferromagnetism.
3 February 2024 in Composites Part A: Applied Science and Manufacturing