Sabine Kellner

Mrs. Sabine Kellner

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 November 2021 in Coatings
Verified
Journal Article
Open access
PDF file
MFMartin Fenker
Martin Fenker
MBMartin Balzer
Martin Balzer
SKSabine Kellner
Sabine Kellner
TPTomas Polcar
Tomas Polcar
ARAndreas Richter
Andreas Richter
TVTomas Vitu
Tomas Vitu
The coating system MoN-Ag is an interesting candidate for industrial applications as a low friction coating at elevated temperatures, due to the formation of lubricous molybdenum oxides and silver molybdates. Film deposition was performed by high-power impulse magnetron sputtering and direct current magnetron sputtering. To facilitate a future transfer to industry Mo-Ag composite targets have been sputtered in Ar/N2 atmosphere. The chemical composition of the deposited MoN-Ag films has been investigated by wavelength dispersive X-ray spectroscopy. Morphology and crystallographic phases of the films were studied by scanning electron microscopy and X-ray diffraction. To obtain film hardness in relation to Ag content and bias voltage, the instrumented indentation test was applied. Pin-on-disc tribological tests have been performed at room temperature and at high temperature (HT, 450 °C). Samples from HT tests have been analyzed by Raman measurements to identify possible molybdenum oxide and/or silver molybdate phases. At low Ag contents (≤7 at.%), coatings with a hardness of 18–31 GPa could be deposited. Friction coefficients at HT decreased with increasing Ag content. After these tests, Raman measurements revealed the MoO3 phase on all samples and the Ag2Mo4O13 phase for the highest Ag contents (~23–26 at.%).

11 February 2021 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
SKSabine Kellner
Sabine Kellner
OROliver Ruger
Oliver Ruger
CVCarmen Voigt
Carmen Voigt
FMFrank Machalett
Frank Machalett
SFSchmidl Frank
Schmidl Frank
Artificial pinning centers based on crystalline gold nanoparticles inside a YBCO matrix are rarely researched so far. Nonetheless we obtained quite promising results by incorporating such particles in superconducting films. Critical current densities of 10 MA/cm2 at 77 K were observed by using small amounts of pinning material (less than 10 vol.%). Generation of gold nanoparticle ensemble inside a YBCO layer is a self-organized process. It takes place while superconductor deposition on a prior deposited gold seed layer. Particle sizes smaller 10 nm as well as some particles around 100 nm were observed. The positive effect on superconducting properties is known from previous investigations but especially the increase in critical current density observed so far is subject to greater fluctuations. In this work various nanoparticle ensembles were investigated directly by use of focus ion beam technique (FIB), scanning electron microscopy (SEM) and energy dispersive x-ray spectroscopy (EDX) in well-defined areas with known local current density. This investigation provides a direct link between gold distribution and the resulting enhancement, which can be utilized to optimise process conditions in direction of favourable particle ensembles.

9 February 2021 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
MSMax Stapelfeld
Max Stapelfeld
SFSchmidl Frank
Schmidl Frank
PSPaul Seidel
Paul Seidel
SSS. Stuck
S. Stuck
VTVolker Tympel
Volker Tympel
SKSabine Kellner
Sabine Kellner
Non-destructive measurements of nA beam currents in particle beam storage rings with a Cryogenic Current Comparator (CCC) are well established. The detection of beam currents with small amplitudes with a CCC in a storage ring demands a high slew rate which is caused by the rapid change of the beam current exceeding the operational limit of the SQUID in flux-locked loop mode. Previous solutions to increase the slew rate used a LCR first-order low-pass were a small resistor, unfortunately, dominated the current noise of the CCC. In this work we present a novel take by adding a second resonator into the CCC which in turn allows for higher resistances of the LCR low-pass and therefore lower thermal current noise. A second challenge connected with this CCC approach is the residual magnetization of the highly magnetic permeable core and the resulting shielding currents in the superconducting circuits of the CCC. The timing of a storage ring in the range of minutes opens a way to reduce these DC currents using a LR highpass filter. Using serial sub-micro ohm resistors time constants in the hour range can be achieved to improve the stability and performance of the CCC system.