CO2 mineralization plays a critical role in the storage and utilization of CO2. Coal fly ash (CFA) and red mud (RM) are widely utilized as CO2 mineralizers. However, the inert calcium species in CFA limit its carbonation capacity, meanwhile the substantial Ca2+ releasing of RM is hindered by a covering layer of calcium carbonate. In this study, CO2 mineralization in a composite system of CFA and RM was investigated to enhance the carbonation capacity. Multiple analyzers were employed to characterize the raw materials and resulting mineralization products. The results demonstrated that a synergistic effect existed in the composite system of CFA and RM, resulting in improving CO2 mineralization rate and efficiency. The produced calcium carbonate was ectopically attached the surface of CFA in the composite system, thus slowing down its coverage on the surface of RM. This phenomenon facilitated further releasing Ca2+ from the internal RM, thereby enhancing CO2 mineralization efficiency. Meanwhile, the inclusion of RM significantly improved the alkalinity of the composite system, which not only promoted the dissolution of Ca2+ of the inert CaSO4(H2O)2 in CFA, but also accelerated CO2 mineralization rate. The investigation would be beneficial to CO2 mineralization using industrial solid wastes.
Coal tar pitch (CTP) is an important heavy carbon resource. Its effective utilization largely depends on the full structural evaluation of CTP. In this paper, the CTP from Shanxi Datuhe coal tar distillation plant was adopted as the sample (DCTP). Multiple analytical equipments including X-ray diffractometer spectrometer, solid-state 13C nuclear magnetic resonance spectrometer, and X-ray photoelectron spectrometer were used to directly characterize DCTP, and DCTP was further catalytically oxidized over ruthenium ion. The typical characteristics of structures in DCTP were investigated by combining the two methods. It was demonstrated that aromatic structures dominated in DCTP, in which the aromaticity was up to 95 %. Specifically, aromatic structures were abundant in peri-condensed aromatic structures, poor in cata-condensed aromatic structures, but short of polyaryl structures. There were about 4 rings in each aromatic cluster, and the aromatic clusters were lowly substituted by a few methyl side chains. Furthermore, the nitrogen and sulfur atoms mainly existed in the heterocyclic ring, while the oxygen one was principally in Car‒O group.
The treatment and resource utilization of solid waste and wastewater are becoming increasingly important. In this study, we propose a method to synthesize sulfur quantum dots using coked sulfur paste as raw material, which produced sulfur quantum dots with good water solubility, good dispersibility and stable luminescence performance. The synthesized sulfur quantum dots were used as a fluorescent probe for sensitively detecting low concentrations of silver ions (Ag+) based on the principle of fluorescence quenching. The detection method has a wide detection range (0–160 μM) with the lowest limit of detection of 7.1 μM and no quenching effect in the presence of 11 common ions, thus enabling the highly selective detection of silver ions. Moreover, a new method for the recovery of silver involving the strong bonding between sulfur quantum dots and silver ions was developed, i.e., even a low concentration of silver ions (under 200 μM) in industrial wastewater was converted into silver sulfide (Ag2S) and silver sulfate (Ag2SO4) for recovery. Results show that the average recovery rate reached 99.03% in the aqueous environment in the presence of five types of hetero-ions, namely, Na+, K+, Ca2+, Mg2+ and Al3+, showing both high efficiency and selectivity. This investigation realized the resourceful utilization of coked sulfur paste and provides a new pathway for the detection and recovery of low concentrations of silver in industrial wastewater.