These days, electric motor qualities and energy-saving problems are significant to our society. The critical component of these problems is related to magnetic materials. In this respect, here, we investigated the (FexCo1−x)72B19.2Si4.8Nb4 (0 ≤ x ≤ 1, at 0.1 intervals) ribbon alloys’ structural, thermal, and magnetic properties. Replacing Co with Fe turned out to increase saturation magnetization up to 127.7 emu/g and improve thermal stability. Additionally, we conducted heat treatment at 843, 893, and 943 K for 10 mins, and the annealing effect in the amorphous (FexCo1−x)72B19.2Si4.8Nb4 (0.4 ≤ x ≤ 0.9, at 0.1 intervals) ribbons on structural and magnetic properties are analyzed. The saturated magnetization (Ms) value has increased by about 20 to 30 emu/g by the heat treatment and tends to increase as the annealing temperature increases until the annealing temperature approaches 893 K. After annealing at 943 K for 10 mins, the highest saturation magnetization of 156.8 emu/g was achieved. In addition, all four samples show the same coercivity trend. The coercivity decreases when the initial heat treatment at 843 K is applied to the ribbons. However, after annealing at this high temperature, such as 893, 943 K, the Fe3B, and (Fe, Co)23B6 phases are also generated and cancel out the good soft magnetic properties of α-(Fe, Co) phase.
The soft magnetic amorphous ribbons of (FexCo1−x)85M9Nb1B5 (M = Zr or Hf, x = 0.4, 0.5, 0.6, 0.7, 0.8, and 0.9) were investigated in this study. Replacing Zr by Hf turned out to increase saturation magnetization and, at the same time, reduce the coercivity, both of which serve together in enhancing the soft magnetic performance of the alloys. Moreover, the optimum ratio of Fe/Co was determined after the survey on different alloys with varying Fe/Co ratio resulting in the maximum saturation magnetization while keeping the coercivity low. After optimization, the highest saturation magnetization of 1.62 T was achieved with coercivity of 11 A/m. While substitution of Hf for Zr slightly reduced the crystallization onset temperature of the amorphous structure, the thermal stability of the soft magnetic amorphous alloys was not significantly affected by the Zr/Hf replacement.