Improving the efficiency of well drilling process in a reservoir is directly related to subsequent well flow rates. Drilling of deviated and horizontal wells is often accompanied by an increase in pressure losses due to flow resistance caused by small size of the annular space. An important role in such conditions is played by the quality of borehole cleaning and transport capacity of drilling fluid, which is directly related to the rheological parameters of the drilling fluid. The main viscosifiers in modern drilling fluids are polymer reagents. They can be of various origin and structure, which determines their features. This work presents investigations that assess the effect of various polymers on the rheological parameters of drilling fluids. Obtained data are evaluated taking into account the main rheological models of fluid flow. However, process of fluid motion during drilling cannot be described by only one flow model. Paper shows experimentally obtained data of such indicators as plastic viscosity, dynamic shear stress, non-linearity index and consistency coefficient. Study has shown that high molecular weight polymer reagents (e.g., xanthan gum) can give drilling fluid more pronounced pseudoplastic properties, and combining them with a linear high molecular weight polymer (e.g., polyacrylamide) can reduce the value of the dynamic shear stress. Results of the work show the necessity of using combinations of different types of polymer reagents, which can lead to a synergetic effect. In addition to assessing the effect of various polymer reagents, the paper presents study on the development of a drilling fluid composition for specific conditions of an oil field.

The development of a new drilling fluid system with hydrate inhibition is of great significance for drilling safety in gas hydrate-bearing sediments. Considering the importance of the selection of a suitable thickener for drilling fluid systems under weak and strong driving forces, the hydrate inhibition of 0.1–0.5 wt% modified starch (MS), carboxymethylcellulose sodium (CMC), and xanthan gum (XG) aqueous solutions was studied. The applicability of these three thickeners were investigated through hydrate formation experiments, mesostructure observations, water activity tests, bubble retention observations, and rheological property tests. The results show that (1) under weak driving force, 0.3 wt% or higher concentration CMC and 0.3 wt% XG can almost completely inhibit hydrate formation due to the interactions between relatively small amounts of free water and CH₄ molecules. Furthermore, the hydrate inhibition of higher XG concentrations was decreased due to their strong foam stability, leading to good contact between free water and CH₄ molecules. Meanwhile, the hydrate inhibition of MS was weaker when compared with that of CMC and XG at the same concentrations. (2) Under strong driving force, the existence of the three 0.1–0.5 wt% thickeners could only slow down the hydrate formation rate, and hydrate inhibition due to XG was slightly better than that of the other two. This result implies that the effects of the different mesostructures on hydrate formation were severely weakened. Finally, (3) the tackifying effect of CMC was found to be stronger than that of XG and MS, and the rheological properties of the CMC solution were shown to be relatively weak compared to those of the XG and MS solutions; the CMC solution showed a more significant increase in viscosity with decreasing temperature, which is related to the differences in the mesostructures. Therefore, when the driving force of hydrate formation is relatively low, CMC is a good choice for the drilling fluid system when there is no requirement for cooling, while XG is more applicable for a system that needs cooling. In the case of a stronger driving force, XG is the optimal choice irrespective of whether the drilling fluid system needs cooling or not.