Simulations of the atmospheric dispersion of methane emissions were created for a region containing 26 oil and gas production sites in the Permian Basin in Texas. Virtual methane sensors were placed at 24 of the 26 sites, with at most 1 sensor per site. Continuous and intermittent emissions from each of the 26 oil and gas production sites, over 4 week-long meteorological episodes, representative of winter, spring, summer, and fall meteorology, were simulated. The trade-offs between numbers of sensors and precision of sensors required to reliably detect methane emissions of 1 to 10 kg/h were characterized. A total of 15 sensors, able to detect concentration enhancements of 1 ppm, were capable of identifying emissions at all 26 sites in all 4 week-long meteorological episodes, if emissions were continuous at a rate of 10 kg/h. More sensors or sensors with lower detection thresholds were required if emissions were intermittent or if emission rates were lower. The sensitivity of the required number of sensors to site densities in the region, emission dispersion calculation approaches, meteorological conditions, intermittency of the emissions, and emission rates, were examined. The results consistently indicated that, for the conditions in the Permian Basin, a fixed monitoring network with approximately one continuous monitor per site is likely to be capable of consistently detecting site-level methane emissions in the range of 5–10 kg/h.
1 August 2001 in Journal of the Air & Waste Management Association
Land use data are among the inputs used to determine dry deposition velocities for photochemical grid models such as the Comprehensive Air Quality Model with extensions (CAMx) that is currently used for attainment demonstrations and air quality planning by the state of Texas. The sensitivity of dry deposition and O3 mixing ratios to land use classification was investigated by comparing predictions based on default U.S. Geological Survey (USGS) land use data to predictions based on recently compiled land use data that were collected to improve biogenic emissions estimates. Dry deposition of O3 decreased throughout much of eastern Texas, especially in urban areas, with the new land use data. Predicted 1-hr averaged O3 mixing ratios with the new land use data were as much as 11 ppbv greater and 6 ppbv less than predictions based on USGS land use data during the late afternoon. In addition, the area with peak O3 mixing ratios in excess of 100 ppbv increased significantly in urban areas when deposition velocities were calculated based on the new land use data. Finally, more detailed data on land use within urban areas resulted in peak changes in O3 mixing ratios of ~2 ppbv. These results indicate the importance of establishing accurate, internally consistent land use data for photochemical modeling in urban areas in Texas. They also indicate the need for field validation of deposition rates in areas experiencing changing land use patterns, such as during urban reforestation programs or residential and commercial development.
Mexico approved amendments to its constitution in December 2013 that initiated transformational changes to its energy sector. This study developed a 2016 bottom-up emissions inventory for volatile organic compounds (VOCs), nitrogen oxides (NOx), sulfur dioxide (SO2), carbon monoxide (CO), and fine particulate matter (PM2.5) from upstream and midstream sector sources, including onshore and offshore well sites, gas flaring, natural gas processing facilities, and natural gas compressor stations, throughout Mexican basins. Crude oil storage tanks at onshore oil well sites and venting and fugitive sources at offshore oil production sites were the primary sources of VOC emissions. Key contributions to NOx, CO, and PM2.5 emissions were from internal combustion engines at offshore oil well sites and midstream operations. SO2 emissions were associated with onshore and offshore gas flaring and boilers and process heaters at natural gas processing facilities. Application of the inventory with the Comprehensive Air Quality Model with Extensions (CAMx) indicated that oil and gas production operations could contribute to ozone and PM2.5 concentrations in Mexican and U.S. states under favorable transport patterns. This study provides a foundation for assessing the implications of Mexico’s future energy policies on emissions and domestic and cross-border air quality and public health.