With the modernization of global navigation satellite systems (GNSS), especially the rapid development of the BeiDou Navigation Satellite System (BDS), more observations of satellites and signals have become available. Using data of the globally distributed MGEX stations, a systematic and comprehensive evaluation of signal characteristics for BDS-3, BDS-2, GPS, and Galileo is conducted in terms of carrier-to-noise ratio (C/N0), code noise, and multipath in the contribution. First, a comprehensive signal quality assessment method for BDS/Galileo/GPS satellites and signals is proposed, including C/N0 modeling and MP modeling. For BDS, the BDS-3 satellites apparently have higher signal power than the BDS-2 satellites at the same frequency such as B1I and B3I, and the signal B2a of BDS-3 is superior to other signals in regard to signal power, which is comparable with the superior Galileo E5 signals and GPS L5. Among all the signals, the observation accuracy of E5 is the highest regardless of receiver types, and next highest are BDS-3 B2a and GPS L5. Due to not being affected by the systematic code errors of BDS-2, the observations of BDS-3 satellites contain smaller multipath errors than that of BDS-2 satellites. As for the multipath suppression performance, the BDS-3 signal B2a, GPS L5, and Galileo E5 and E5b perform better than the other signals, which may be related to their wide signal bandwidths.

The radio determination service system (RDSS), a navigation and positioning system independently developed by China, features services such as short-message communication, position reporting, and international search and rescue. The L-band pseudo-range and phase data are the primary data sources in precise orbit determination (POD) for geostationary Earth orbit (GEO) satellite in the BeiDou system, especially in the orbit manoeuvre period. These data are the only data sources in the POD for GEOs. However, when the pseudo-range and phase data is abnormal due to unforeseen reasons, such as satellite hardware failure or monitoring receiver abnormalities, the data abnormality leads to orbit determination abnormalities or even failures for GEOs, then the service performance and availability of the RDSS system are greatly degraded. Therefore, a new POD method for GEOs based on BeiDou short-message communication ranging data has gained research attention to improve the service reliability of the BeiDou navigation satellite system (BDS)-3, realising the deep integration of communication and navigation services of the BDS. This problem has not been addressed so far. Therefore, in this study, a new POD method for GEO satellites is investigated using high-precision satellite laser ranging (SLR) data and RDSS data. The SLR data are used as the benchmark to calibrate the time delay value of RDSS equipment, and RDSS data are only used in the orbit determination process by fixing the corrected RDSS time delay value, and the satellite orbit parameters and dynamic parameters are solved. Experimental analysis is conducted using the measured SLR and RDSS data of the BDS, and the orbit accuracy in this paper is evaluated by the precise ephemeris of the Multi-GNSS pilot project (MGEX) and SLR data. The results show that the orbit accuracy in the orbital arc and the 2-h orbital prediction arc for GEOs are 6.01 m and 6.99 m, respectively, compared with the ephemeris of MGEX, and the short-arc orbit accuracy after 4 h of manoeuvring is 11.11 m. The orbit accuracy in the radial component by SLR data is 0.54 m. The required orbit accuracy for GEO satellites in the RDSS service of the BDS-3 is 15 m. The orbit accuracy achieved in this paper is superior to that of this technical index. This method expands the application field of the RDSS data and greatly enriches the POD method for GEOs. It can be adopted as a backup technology for the POD method for GEOs based on RNSS data, significantly improving the service reliability of the BeiDou RDSS service.

The inter-satellite link is an important technology to improve the accuracy of clock offset measurement and prediction for BeiDou Navigation Satellite System (BDS). At present, BDS measures clock offsets of invisible satellite mainly through the “one-hop” reduction mode based on the satellite-ground clock offset of the node visible satellite and the inter-satellite clock offset between the two satellites. However, there exists a systematic deviation caused by the node satellite reduction, and there is still a large room for improvement in clock offset measurement and prediction. Therefore, this paper firstly proposes a method of whole-network adjustment for clock offset based on the satellite-ground and inter-satellite two-way data. The least square method is used to realize the whole-network adjustment of clock offset based on the observations of two sources, and to obtain optimal estimates of different clock offset reduction. Secondly, the evaluation method combining internal and external symbols are proposed by the fitting residual, prediction error and clock offset closure error. Finally, experimental verification is completed based on BDS measured data. In comparison with the “one-hop” reduction method, the fitting residual and prediction error of the whole-network adjustment method reduces about 45.06% and 52.15%, respectively. In addition, inter-satellite station closure error and three-satellite closure error are reduced from 0.69 ns and 0.23 ns to about 0 ns. It can be seen that the accuracy of BDS time synchronization is significantly improved.