Microplastic contamination is a growing threat to marine and freshwater ecosystems, agricultural production, groundwater, plant growth and even human and animal health. Disintegration of plastic products due to mainly biochemical or physical activities leads to the formation and existence of microplastics in significant amounts, not only in marine and freshwater environments but also in soils. There are several valuable studies on microplastics in soils, which have typically focused on environmental, chemical, agricultural and health aspects. However, there is also a need for the geotechnical engineering perspective on microplastic contamination in soils. In this review paper, first, degradation, existence and persistence of microplastics in soils are assessed by considering various studies. Then, the potential role of solid waste disposal facilities as a source for microplastics is discussed by considering their geotechnical design and addressing the risk for the migration of microplastics from landfills to soils and other environments. Even though landfills are considered as one of the main geotechnical structures that contribute to the formation of considerably high amounts of microplastics and their contamination in soils, some other geotechnical engineering applications (i.e., soil improvement with tirechips, forming engineering fills with dredged sediments, soil improvement with synthetic polymer-based fibers, polystyrene based lightweight fill applications), as potential local source for microplastics, are also mentioned. Finally, the importance of geotechnical engineering as a mitigation tool for microplastics is emphasized and several important research topics involving geotechnical engineering are suggested.
7 January 2021 in Bulletin of Engineering Geology and the Environment
In order to evaluate the shear strength parameters of an anionic polymer-added bentonite-sand mixture that was permeated with tap water, Proctor compaction tests and direct shear tests were performed on the mixture with a bentonite content of 15% by mass. The polymer content in the polymer-bentonite mixture was chosen as 0.5, 1, 2, 5, 10, 15 and 20% by mass, respectively. According to the results, maximum dry unit weight (Vdmax) first decreased as the polymer content was increased to 1% and then, increased. Vdmax of 20% polymer-added mixture and the mixture without polymer addition was measured as 17.55 and 17.28 kN/m3, respectively. Test results indicated that cohesion (c) increased and internal friction angle (ø) decreased due to polymer addition. 2% polymer addition caused an increase of 42 kPa in c but a decrease of 4.2° in ø. As the polymer content increased, maximum shear strength of the mixture (τmax) increased. τmax increased from 171.8 to 197.8 kPa as the polymer content was increased from 0 to 2%. As a result, 2% anionic polymer-added bentonite-sand mixture provided sufficient increase in the shear strength of the mixture.