In past centuries, reservoir landslides have been always a threat that brought a big loss in lives and properties. The phenomena that have decisive influence on the landslide instability are quite complex and the importance of each of them for the stability of a particular landslide differs. Therefore, it is extremely important to distinguish between the effects that different phenomena have and to identify those that dominate the behaviour of the studied landslide. The aim of the present study is to investigate the behaviour under the river level fluctuation of a large landslide in China, namely the Huangtupo landslide. A 2D numerical model of a selected part of the Huangtupo landslide is created and a series of fully coupled hydro-mechanical simulations have been conducted to investigate the landslide behaviour under different influencing factors (e.g., mechanical incidents, water head, soil water permeability, etc.). Furthermore, both local and global sensitivity analyses are performed to assess the importance of these influencing factors and to select the most influential model parameters. Thereafter, back analysis is employed to calibrate the model against real field data. Finally, the capability of the calibrated model is evaluated and the results show that it can simulate appropriately the long-term behaviour of the landslide after the river level reaches its maximal level.
Performing parameter identification for model calibration prior to numerical simulation is an essential task in geotechnical engineering. However, it has to be kept in mind that the accuracy of the obtained parameter is closely related to the chosen experimental set-up, such as the number of sensors as well as their location. A well considered position of sensors can increase the quality of the measurement and reduce the number of monitoring points. This paper illustrates this concept by means of a loading device that is used to identify the stiffness and permeability factor of soft clays. With an initial set-up of the measurement devices the pore water pressure and the vertical displacements are recorded and used to identify the aforementioned parameters. Starting from these identified parameters, the optimal measurement set-up is investigated with a method based on global sensitivity analysis. This method shows an optimal sensor location assuming three sensors for each measured quantity.