Demodulation is a bottleneck for applications involving fiber Bragg gratings (FBGs). An overlap spectrum FBG sensor based on a light power demodulation method is presented in this paper. The demodulation method uses two chirp FBGs (cFBGs) of which the reflection spectra partially overlap each other. The light power variation of the overlap spectrum can be linked to changes in the measurand, and the sensor function can be realized via this relationship. A temperature experiment showed that the relationship between the overlap power spectrum of the FBG sensor and temperature had good linearity and agreed with the theoretical analysis.
Low current sensitivity and insufficient system stability are two key problems in all-fiber current sensor (AFCS) studies. In order to solve the two problems, a novel AFCS combining single-polarization single-mode (SPSM) couplers and a loop structure is presented in this paper with a design that incorporates the advantages of both SPSM couplers and a loop structure. SPSM couplers are shown to simplify the AFCS system and reduce the risk of interference, and the loop structure can enhance the current sensitivity. Both theory and experiment prove that the new AFCS can simultaneously overcome two prevalent obstacles of low current sensitivity and low stability.
We have experimentally developed a hybrid-structure multi-channel all-fiber current sensor with ordinary silica fiber using fiber loop architecture. According to the rationale of time division multiplexing, the sensor combines parallel and serial structures. The purpose of the hybrid-structure multi-channel all-fiber current sensor is to get more information from the different measured points simultaneously. In addition, the hybrid-structure fiber current sensor exhibited a good linear response for each channel. A three-channel experiment was performed in the study and showed that the system could detect different current positions. Each channel could individually detect the current and needed a separate calibration system. Furthermore, the three channels will not affect each other.
A new channel drop filter (CDF) is proposed based on a race-track photonic crystal ring resonator composed of square-lattice cylindrical silicon rods in air. By using a two-dimensional finite-difference, time-domain numerical technique, the modal behavior of two representative CDFs, parallel and perpendicular, has been analyzed. The analyses include the impact of additional scatterer size, scatterer amount and their position on the performance of proposed CDFs, such as drop efficiency and quality factor (Q). For the parallel CDF, about 130 spectral Q and 99% drop efficiency can be optimally achieved at 1363 nm channel with 0.145 periodicity scatterer size, whereas for the perpendicular one, about 180 spectral Q and 99% drop efficiency can be optimally obtained at 1366 nm channel with 0.165 periodicity scatterer size. By increasing the number of scatterers, the efficiency of both configurations can be enhanced. No obvious variation is obtained by changing the scatterer position.