The main obstacle to the widespread use of hydrothermal liquefaction (HTL) for waste and wet biomass recycling is the formation of a significant amount of highly polluted wastewaters. This paper presents an analysis of the chemical composition and toxicity of aqueous phase from the HTL (HTL-AP) of primary and secondary sludge. It was shown that HTL-AP has a high level of organic pollution (total organic carbon (TOC) = 4.2–9.6 g/dm3, chemical oxygen demand (COD) = 7.9–14.0 g/dm3, BOD5 = 6.0–8.1 g/dm3) and high biological toxicity for traditional test organisms (so that dilution ratio, ensuring the death of no more than 50% of organisms (DR50), varied within 64.7–142.2 and 44.9–81.7 for Artemia salina and Paramecium caudatum, respectively). An analysis of HTL-AP composition with NMR-spectroscopy method allowed us to establish that the share of carbon in aliphatic chains was 34.05–41.82% and the content of carbon in carboxyl groups and aromatic rings was 26.42–34.44%. As a result, we can conclude that the main HTL-AP components are fatty carboxylic acids and their derivatives, aromatic carboxylic acids. The content of aldehydes, ketones, and lignin is less than 8%. Biological treatment of HTL-AP in a lab-scale aerobic reactor turned out to be successful, so average COD reduction was 67–95%. Sludge from an industrial waste water treatment plant (petrochemical sector) with a microorganism concentration of 2.7 g/dm3 was used as inoculum. HTP-AP was diluted 1:10 with tap water. The duration of the process was 18 h.
1 February 2011 in Russian Journal of Organic Chemistry
Reactions of ( Z)-3-(phenacylidene-2-oxo)-3,4-dihydroquinoxalin-2(1 H)-ones and ( Z)-3-(3,3-dimethyl-2-oxobutylidene)-3,4-dihydroquinoxalin-2(1 H)-one with oxalyl chloride led to the formation of...
12 November 2019 in Organic & Biomolecular Chemistry
A facile method for the synthesis of meta-substituted arylamines from acyclic precursors was developed. This method is based on three-component cyclo-condensation/aromatization of in situ generated imines of acetone with 1,3-diketones either under conventional heating or under microwave irradiation. The utility of this methodology is illustrated by the possibility of a gram scale synthesis of various anilines from readily available reagents.
1 February 2012 in Pharmaceutical Chemistry Journal
Hydrothermal liquefaction (HTL) of sewage sludge is considered in the article as an analogue of the natural processes of oil formation (catagenesis). A comparison of the physicochemical composition of primary and secondary sludge with type II kerogen (natural precursor of oil) showed their similarity. Both types of sludge have a slightly higher level of oxygen and nitrogen. The study tested the hypothesis that the elements included in the inorganic part of the oil source rocks can have a catalytic effect on the oil formation processes. For the conducted studies of sludge HTL, the catalysts containing cations and substances found in oil source rocks were chosen: as homogeneous catalysts (KOH, NaOH, NH4Fe(SO4)2, CoCl6, NiSO4, CuSO4, ZnSO4, MoO3) and as heterogeneous catalysts (MgO, Zeolite, Al2O3). The effectiveness of catalysts containing metal ions, zeolite and aluminum oxide has been proven. The highest biocrude yield was achieved in a process with NiSO4 as the catalyst in a dose 2 g per 10 g of sludge: oil yield increased by 34.9% and 63.4% in the processing of primary and secondary sludge, respectively. The use of catalysts provided an increase in fuel HHV by 10.8–12.5%, which is associated with a decrease in oxygen content (by 10.8–43.2%) with a simultaneous increase in carbon (by 7.9–10.9%) and hydrogen (by 6.5–18.7%) content.