Yvonne Ilmberger

Ms. Yvonne Ilmberger

orcid

Research Focus & Metrics

Academic Career Length

6Years (2021-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 December 2021 in Polymers
Verified
Journal Article
Open access
PDF file
KLKlara Loos
Klara Loos
VBVivianne Marie Bruère
Vivianne Marie Bruère
BDBenedikt Demmel
Benedikt Demmel
YIYvonne Ilmberger
Yvonne Ilmberger
ALAlexander Lion
Alexander Lion
MJMichael Johlitz
Michael Johlitz
The present study investigates different elastomers with regard to their behavior towards liquids such as moisture, fuels, or fuel components. First, four additively manufactured materials are examined in detail with respect to their swelling in the fuel component toluene as well as in water. The chemical nature of the materials is elucidated by means of infrared spectroscopy. The experimentally derived absorption curves of the materials in the liquids are described mathematically using Fick’s diffusion law. The mechanical behavior is determined by uniaxial tensile tests, which are evaluated on the basis of stress and strain at break. The results of the study allow for deriving valuable recommendations regarding the printing process and postprocessing. Second, this article investigates the swelling behavior of new as well as thermo-oxidatively aged elastomers in synthetic fuels. For this purpose, an analysis routine is presented using sorption experiments combined with gas chromatography and mass spectrometry and is thus capable of analyzing the swelling behavior multifacetted. The transition of elastomer constituents into the surrounding fuel at different aging and sorption times is determined precisely. The change in mechanical properties is quantified using density measurements, micro Shore A hardness measurements, and the parameters stress and strain at break from uniaxial tensile tests.

28 October 2025 in Materialwissenschaft und Werkstofftechnik
Verified
Journal Article
Open access
YIYvonne Ilmberger
Yvonne Ilmberger
TFT. Förster
T. Förster
SES. Eibl
S. Eibl
This study investigates the effects of different processing methods on the chemical composition of thermoplastic polyurethanes, focusing on isocyanates and extractable oligomers. Using diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS) and gas chromatography/mass spectrometry (GC/MS), seven commercially available thermoplastic polyurethane samples are analyzed as unprocessed granulate, injection‐molded, and 3D‐printed parts. Diffuse reflectance infrared Fourier transform spectroscopy analysis enables direct identification and quantification of isocyanates. In two polyester‐based materials, substantial isocyanate contents were detected after processing. In both cases, the concentrations exceeded the w = 0.1 % threshold defined by REACH Regulation (EU) 2020/1149 for monomeric diisocyanates, thereby underscoring the regulatory significance of processing‐induced changes. Gas chromatography/mass spectrometry analysis complements these results by indirectly but quantitatively detecting the formation of oligomers during processing via methylene diphenyl diisocyanate. The highest isocyanate content determined was w = 1.16 % in an injection‐molded sample. The comparison of both methods shows their complementary significance in isocyanate detection. The study highlights the importance of choosing the correct processing parameters and analytical techniques to ensure thermoplastic polyurethane integrity and reduce undesirable changes in material composition.