Flexible alternating current electroluminescent (ACEL) devices have attracted growing interest as promising wearable displays for their uniformity of light emission, low power consumption, and excellent reliability. However, the requirement of high-voltage power sources for driving ACEL devices greatly impedes their portability and commercialization. Here, we developed flexible ACEL devices integrated with high output-voltage triboelectric nanogenerators (TENG) using easy and low-cost crumpled Al electrodes. The output voltage and current could reach as high as 490 V and 71.74 μA, corresponding to the maximum instantaneous output power density of 1.503 mW cm⁻², which was demonstrated to power an integrated flexible ACEL patterned display. In addition, through signal acquisition and transmission, ACEL can display the compression frequency of TENG in real time. Such self-powered ACEL devices are very promising as flexible displays in wearable electronics.

Stretchable and wearable opto-electronics have attracted worldwide attention due to their broad prospects in health monitoring and epidermal applications. Resistive strain sensors, as one of the most typical and important device, have been the subject of great improvements in sensitivity and stretchability. Nevertheless, it is hard to take both sensitivity and stretchability into consideration for practical applications. Herein, we demonstrated a simple strategy to construct a highly sensitive and stretchable graphene-based strain sensor. According to the strain distribution in the simulation result, highly sensitive planar graphene and highly stretchable crumpled graphene (CG) were rationally connected to effectively modulate the sensitivity and stretchability of the device. For the stretching mode, the device showed a gauge factor (GF) of 20.1 with 105% tensile strain. The sensitivity of the device was relatively high in this large working range, and the device could endure a maximum tensile strain of 135% with a GF of 337.8. In addition, in the bending mode, the device could work in outward and inward modes. This work introduced a novel and simple method with which to effectively monitor sensitivity and stretchability at the same time. More importantly, the method could be applied to other material categories to further improve the performance.