The paper presents the results of studies on the effects of heat treatment and cold-work parameters on the mechanical properties and microstructure of the tungsten heavy alloy (WHA) with the composition W91-6Ni-3Co. Tungsten heavy alloy (WHA) is used in conditions where strength, high density, and weight are required. The material for testing as rod-shaped samples was produced by the method of powder metallurgy and sintering with the participation of the liquid phase and then subjected to heat treatment and cold swaging. The study compares the effect of degree deformation on the strength, hardness, microhardness, and microstructure of WHA rods. The conducted tests showed that heat treatment and cold-work allowed to gradually increase the strength parameters, i.e., tensile strength , yield strength , elongation ε, hardness, and microhardness. These processes made it possible to increase the tensile strength by over 800 MPa (from the initial 600 MPa after sintering to the final value of over 1470 MPa after heat treatment with cold swaging deformation with reduction of 30%) and the hardness from 32 to 46 HRC.
The paper concerns modelling the dynamics of the contact system of the tested sample with an elastic half-space (anvil) during their collision. The original elements in the paper include the proposed general approach to solving the problem of contact dynamics. The presented approach consists in determining the force of impact on the sample during the collision and the joint solution of the problem for the tested sample and the problem for an elastic semi-space under the conditions of the assumptions of Hertz’s theory. The resulting interaction forces allow the determination of displacements and stresses.
The article concerns the modeling of the transverse impact of an impactor (test sample) on the surface of an infinite elastic layer. The Laplace transform with respect to time and the Hankel transform with respect to the radius for the axisymmetric case were applied. The propagation of elastic waves in the layer and local deformations in the contact zone are taken into account. Impact force, impact time and the coefficient of restitution were examined. The results are compared with the elastic half-space. The calculations carried out showed that for layer thicknesses of more than five impactor diameters, the layer can be considered as a half-space.
About Me
Faculty of Mechanical and Industrial Engineering, Narbutta 85, 02-524 Warszawa
Faculty of Mechanical and Industrial Engineering, Narbutta 85, 02-524 Warszawa