Alexander Ponomarev

Prof. Dr. Alexander Ponomarev

orcid

Research Focus & Metrics

Academic Career Length

22Years (2005-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2019 in Carbon
Verified
Journal Article
Closed access
NBN.G. Bobenko
N.G. Bobenko
VBV.V. Bolotov
V.V. Bolotov
VEV.E. Egorushkin
V.E. Egorushkin
Petr M. KorusenkoPetr M. Korusenko
Petr M. Korusenko
NMN.V. Melnikova
N.V. Melnikova
SPS.N. Povoroznyuk
S.N. Povoroznyuk

25 March 2019 in Applied Nanoscience
Verified
Journal Article
Closed access
PDF file
MBMaksym Barabashko
Maksym Barabashko
MTM. V. Tkachenko
M. V. Tkachenko
ANA. A. Neiman
A. A. Neiman
APAlexander Ponomarev
Alexander Ponomarev
ARA. E. Rezvanova
A. E. Rezvanova

1 August 2022 in Materials
Verified
Journal Article
Open access
PDF file
MBMaksym Barabashko
Maksym Barabashko
APAlexander Ponomarev
Alexander Ponomarev
ARAnastasiya Rezvanova
Anastasiya Rezvanova
VKVladimir Kuznetsov
Vladimir Kuznetsov
SMSergey Moseenkov
Sergey Moseenkov
The Vickers hardness and Young’s modulus of the hydroxyapatite (HA) bioceramics with a small amount of the multi-walled carbon nanotubes (MWCNTs) were studied by using ultramicrotester Shimadzu for dynamic tests DUH-211. Small concentrations of MWCNTs were from 0.05 to 0.5 wt.%. The argon inert atmosphere and vacuum condition were taken for the prevention of the MWCNTs oxidation. The Brunauer–Emmett–Teller (BET) surface area SBET of the HA-MWCNTs composites was determined by thermal adsorption-desorption of nitrogen. It was found that for HA-MWCNTs sintered in the Ar atmosphere, an increase in the concentration of nanotubes up to 0.5 wt.% leads to a decrease in porosity near 3 times in comparison to HA without MWCNTs additives. The small amount of additives of multi-walled carbon nanotubes leads to an increase in hardness of 1.3 times and compression strength of composite and compression strength of composite that is comparable in absolute values with the literature data of enamel hardness (3–5 GPa) and compression strength (95–370 MPa). The absolute values increase close to linearly with the increase of nanotube concentrations. The Young’s modulus of sintered composite slightly changes with the variation of concentrations of nanotubes and close to the enamel (75–100 GPa). The ratio of plastic work to total work and the ratio of elastic (reversible) work to the total work of deformation of composite HA/MWCNTs are practically constant at a studied range of MWCNTs concentration. The additives of the multi-walled carbon nanotubes lead to both an increase in the elasticity index of ~1.5 times and an increase in the resistance to plastic deformation of ~3 times, which improved the tribological performance of the surface. Plastic and elastic (reversible) work slightly changed.

1 March 2019 in Low Temperature Physics
Verified
Journal Article
Closed access
PDF file
VSV. V. Sumarokov
V. V. Sumarokov
AJA. Jeżowski
A. Jeżowski
DSD. Szewczyk
D. Szewczyk
MBM. I. Bagatski
M. I. Bagatski
MBM. S. Barabashko
M. S. Barabashko
SMS. I. Moseenkov
S. I. Moseenkov
The specific heat of multi-walled carbon nanotubes (MWCNTs) with a low defectiveness and with a low content of inorganic impurities has been measured in the temperature range from 1.8 to 275 K by the thermal relaxation method. The elemental composition and morphology of the MWCNTs were determined using scanning electron microscopy analysis and energy dispersion x-ray spectroscopy. The MWCNTs were prepared by chemical catalytic vapor deposition and have mean diameters from 7 nm up to 18 nm and lengths in some tens of microns. MWCNTs purity is over 99.4 at.%. The mass of the samples ranged from 2–4 mg. It was found that the temperature dependence of the specific heat of the MWCNTs differs significantly from other carbon materials (graphene, bundles of SWCNTs, graphite, diamond) at low temperatures. The specific heat of MWCNTs systematically decreases with increasing diameter of the tubes at low temperatures. The character of the temperature dependence of the specific heat of the MWCNTs with different diameters demonstrates the manifestation of different dimensions from 1D to 3D, depending on the temperature regions. The crossover temperatures are about 6 and 40 K. In the vicinity of these temperatures, a hysteresis is observed.

11 September 2020 in Fullerenes, Nanotubes and Carbon Nanostructures
Verified
Journal Article
Closed access
MBMaksym Barabashko
Maksym Barabashko
MDM. Drozd
M. Drozd
Daria SzewczykDaria Szewczyk
Daria Szewczyk
AJA. Jeżowski
A. Jeżowski
MBM. I. Bagatskii
M. I. Bagatskii
DSD. A. Smirnov
D. A. Smirnov
DSC and calorimetric studies of multi-walled carbon nanotubes (MWCNTs) with average diameters in the range 7, 9 and 18 nm were carried out. MWCNTs were obtained by the CVD method. The kinetic processes in MWCNTs were studied from room temperature to 550 °C in a nitrogen flow using differential scanning calorimetry (DSC) on a Perkin – Elmer — 8000. It was found that exo- and endothermic peaks are not observed on the DSC curves after water evaporation. This indicates that all studied MWCNTs have a small number of defects, functional groups, and other impurities. The heat capacity of MWCNTs was measured by the relaxation method in the temperature range from 2 to 275 K by using PPMS. In the temperature dependences of the specific heat were observed that for MWCNTs with the decrease of the temperature below 20 K the curves shift to lower values with an increase the average diameter. The main result was that at temperatures below 45 K with the decreasing of the nanotubes diameter the ratio of heat capacity of nanotubes to the heat capacity of graphite increases. The perfection of structure and low amount of the defects, functional groups and impurity contamination for MWCNTs were demonstrated in the comparison of the XPS and NEXAFS spectra for these nanotubes with CVD prepared nanotubes (18 nm) after mechanical and chemical functionalization.

1 June 2014 in Physica E: Low-dimensional Systems and Nanostructures
Verified
Journal Article
Closed access
NBN.G. Bobenko
N.G. Bobenko
VEV.E. Egorushkin
V.E. Egorushkin
NMN.V. Melnikova
N.V. Melnikova
APAlexander Ponomarev
Alexander Ponomarev